KENMORE ELITE 796.6155 Serie Manual De Uso página 18

INSTALLATION INSTRUCTIONS
REVERSING THE TWO-WAY DOOR (continued)
hinge
cover
latch
mechanism
hinge
d. Reverse the hinge and the hinge bracket at the
bottom of the cabinet. Remove the two screws
from the hinge bracket at bottom right and remove
the hinge bracket.
Remove the lower of the two screws
behind the hinge bracket. Do NOT
remove the upper screw behind the
hinge bracket. Set the parts aside.
NOTE:
Do NOT remove any of the eight screws on the
face of the cabinet (marked with
Doing so could result in damage to the dryer and
the need for a service call to repair the dryer.
e. Remove the three screws on the
hinge at bottom left. Remove the
hinge and reinstall it on the right
side. The top screw occupies the
hole where you removed the screw
behind the hinge bracket in step d.
f. Install the hinge bracket removed in
step d on the bottom left side, fi rst installing one
screw behind the hinge bracket.
cabinet reversal complete
latch hole
cover
hinge
bracket
INSTALLATION INSTRUCTIONS
On the Door:
upper
4
Lift off the door cover.
hinge
With the door laid inside facing up on a protected
latch
surface, remove the 12 screws on the inside of the
hole
door. Carefully lift off the door cover with the help
cover
of a small flat-blade screwdriver inserted in the
upper corner (circled below).
hinge
bracket
The edges of the door cover may be sharp. Take care
when handling, or wear gloves to avoid injury.
below).
5
Switch the door strike and the blank cover.
Remove the four screws on the door cover that secure
the door strike and the blank cover.
Switch the door strike and the blank cover, installing
them on the opposite sides from which they were
removed.
hinge
cover
Gently pry out the hole plug on the
latch
side of the door cover and install it
mechanism
in the hole on the opposite side.
Set the door cover aside.
hinge
18
CAUTION:
Twelve screws
Hole Side
plug Interlock
button
Short
screws
Blank cover
Pull
Remove blank cover
Long
screw
Door strike
Raise
Hole
plug