Maytag MVWX5SPAW Manual De Uso Y Cuidado página 9

8.
Select cycle modifiers
Once you select a cycle, the default settings for that cycle will be
lit. Press the cycle modifiers buttons to change the Temperatura
(Temperature), Suciedad (Soil Level), and Exprimido (Spin Speed),
if desired.
NOTE: Always read and follow fabric care labels instructions to
avoid damage to your garments.
Temperature
Caliente (Hot)
Some cold water is added to save
energy. This may be cooler than
your hot water heater setting.
Tibia (Warm)
Some cold water may be added,
so this will be cooler than what
your previous washer provided.
Semi Fría (Cool)
Warm water is added to assist
in soil removal and to help
dissolve detergents.
Fría (Cold)
Warm water may be added to
assist in soil removal and to help
dissolve detergents.
9.
Select cycle options
Select any other cycle options you may wish to add, if not
previously set. Some cycles will automatically add certain
options such as Extra enjuague (Extra Rinse). These can be
turned off, if desired.
NOTE: Not all options are available with all cycles.
Suggested Fabrics
Whites and pastels
Durable garments
Heavy soils
Bright colors
Moderate to light soils
Colors that bleed
or fade
Light soils
Dark colors that
bleed or fade
Light soils
10.
Press INICIO/PAUSA/
DESBLOQUEAR TAPA (Start/
Pause/Unlock) to begin cycle
Press the INICIO/PAUSA/DESBLOQUEAR TAPA (Start/Pause/
Unlock) button to start the wash cycle. Filling is delayed for
several minutes while load balance is sensed. When the cycle
has finished, the FIN (Done) indicator will light up. Promptly
remove garments after cycle has completed to avoid odor,
reduce wrinkling, and rusting of metal hooks, zippers, and snaps.
Unlocking the lid to add garments
If you need to open the lid to add 1 or 2 missed garments:
Press INICIO/PAUSA/DESBLOQUEAR TAPA (Start/Pause/Unlock);
the lid will unlock once the washer movement has stopped. This
may take several minutes if the load was spinning at high speed.
Then close lid and press INICIO/PAUSA/DESBLOQUEAR TAPA
(Start/Pause/Unlock) again to restart the cycle.
If lid is left open for more than 10 minutes the water will
pump out.
Delay in water fill
Filling is delayed for 2 to 3 minutes to check for load unbalance.
You will hear the hum of the spin prior to filling. This is normal
operation.
9