Cardin YPR851BCC Manual Del Usuario página 11

4) Press the previously chosen channel buttons on the transmitter which
you wish to memorise; the receiver will sound 2 "beeps" of half a second
each after which the receiver will be ready to receive another code.
5) To leave the programming mode wait for 5 seconds without pressing any
buttons. The receiver will sound a five-second long "beep" and will then
exit the programming mode.
• When the memory is entirely occupied the buzzer will sound 10 rapid
"beeps" and will automatically leave the "programming via radio" mode.
LED "L2" will remain lit. The same signal is given each time you try to
enter "programming via radio" when the memory is full.
CONNECTING THE 433 MHZ MODULE ANTENNA
The receiver is supplied with its own antenna which consists of a piece of
rigid wire 70 mm in length. In alternative it is possible to connect an ANS400
tuned antenna using a coaxial cable RG58 (impedance 50Ω) with a maximum
length of 5 m.
BATTERY CHARGER (OPTIONAL)
If the electronic programmer has been fitted with the battery charger unit
PRG850BC it can work off battery power during blackouts.
The following indications should be taken into account:
• To indicate that the programmer is working off battery power when the boom
is completely closed a hyphen flowing around the perimeter of the display
will appear (see page 8). When the battery is completely flat the letter
appear on the display and the programmer will block completely (only when
the boom is completely closed). When the power supply returns and the
battery begins to recharge the system will automatically be freed and the
indication on the display will change.
Make sure external devices are correctly connected so they can
work off the direct current supplied by the battery.
• In the battery powered mode it is possible to enter programming and modify
the system parameters and the torque limiter selection. When the pause symbol
appears after "L3", pressing the "PROG" button will force the program to
quit.
Changing the batteries
The batteries must be changed by authorised technicians and the
flat batteries are to be disposed of according to the local standards
and regulations in course.
At the end of the control unit's life span and before disposing of
the unit makes sure you remove the batteries and dispose of them
separately.
For ulterior instructions regarding the installation of the bat-
tery charger consult the instruction manual supplied with
the product.
will