Operation - Silit Ecolare Indicaciones De Manejo Y Cuidado

Stand-by-display
ON/OFF button
Temperature
Start-up
I
nsert the plug into the socket. Then turn on the
switch on the back right side of the device. A
signal will go off and all displays will light up for
approx. second. Then only the red standby-LED
above the ON/OFF button
nated.
Put an induction-compatible pot or pan in the
middle of the cooking zone. If you press the ON/
OFF button once, lines will appear on the
display and the red stand-by LED will blink.
The device will wait for you to select the desired
mode (temperature or power output). Attention:
after seconds the device will return to stand-
by mode if you do not press a function key ( or
).
Temperature
Press the ON/OFF button
temperature button once. A green LED above
the temperature button will light up and the
red stand-by LED will go out. The display will
show °C and the temperature icon and a bar
will appear in the lower left-hand corner of the
display. Now you can set a temperature between
- °C using the dial regulator. You can turn it
to the right (+) or the left (-). Every time the tem-
perature is changed, the current temperature is
Power output Residual heat display
Timer
will remain illumi-
once and then the

Operation

o
C
min
Display
shown on the display and the length of the bar
will change accordingly.
You can set the temperature as follows: from
to °C in increments of °C, from
in increments of °C and from
increments of °C.
Power output
Press the ON/OFF button
the power output button
will light up above the power output button and
the red stand-by LED will go out. A will appear
on the display along with the power output icon
and a bar will appear in the lower left-hand cor-
ner. Now you can select a power output setting
between and using the dial regulator. You
can turn it to the right (+) or the left (–). Every
change in power output is shown on the display
and the length of the bar will change accordingly.
Timer
First activate the temperature or power
output mode. To set the timer now, do the fol-
lowing (fig.).
If no change is made during seconds while
setting the timer, the device will return to the
previously selected mode. In order to switch off
Dial regulator
to °C
to °C in
once and then press
once. A green LED
EN
13