Power Source; Basic Functions; Radio Operation - Trevi XF 700 Guia Del Usuario

ENGLISH XF 700

POWER SOURCE

This unit works with direct AC mains supply AC 100-240V 60/50Hz
To TURN ON the unit 'plug the power cord into the outlet on the device (27) and the plug into a power outlet.
Do not connect the appliance to sockets with a voltage other than specified.

BASIC FUNCTIONS

TURNING THE UNIT ON/OFF
After connecting the power, then press the STANDBY button (22) on the front cabinet to turn on unit.
Note: If you don't use the unit for a long time, disconnect the AC power cord from the household wall outlets.
NOTE: In USB/AUX/BT position, when the unit is not providing the main function for 15 minutes, the unit will automatically switch
in to standby mode. Press the STANDBY button (22) again to turn on the unit.
Please note that low volume setting in the audio source maybe recognized as "no audio signal", this will affect the capability of
signal detection from the device and can also originate an automatic switch into standby mode. If this happens please reactivated
the audio signal transmission or increase the volume setting on the audio source player in order to resume playback.
ESD hints: The product maybe reset or not reset to operation of control due to electrostatic discharge, just switch off and re-
connect again.
SETTING THE FUNCTION MODE
To change the function modes, press the FUNCTION button(19) to choose USB/AUX IN/BT/RADIO function.
ADJUSTING THE VOLUME
1. Rotate the VOLUME knob (7) on the unit to increase or decrease the music volume.
2. Rotate the MIC VOL. knob (8) on the unit to increase or decrease the microphone volume.
EQUALIZER (EQ) FUNCTION
This unit has a built-in equalizer system, adjust the EQ bar (4) by five frequencies (100Hz, 330Hz, 1KHz, 3.3KHz, 10KHz) on unit
to select a setting that best matches the music style.
TREBLE ADJUSTMENT
Rotate the TREBLE knob (5) on unit to increase or decrease the treble effect that best matches the music style.
MICROPHONE ECHO ADJUSTMENT
Rotate the ECHO knob (6) on unit to increase or decrease the microphone echo effect that best matches the style.
DISCO-LIGHT
To change the disco light effects, press the LIGHT button (15) on unit. You can choose from five different flashing modes.
To disable the disco light, press the LIGHT button (15) on unit until the display shows "OFF".

RADIO OPERATION

Listen to FM radio broadcasts. Press the FUNCTION button (19) until the display reads FM and the radio frequency.
TUNING TO A RADIO STATION
If you know the station frequency that you want to tune to directly:
• Tune to a station by rotate the TUNING knob (21). The station frequency is shown on the display.
AUTO PRESET MEMORY/SCAN
To scan for stations within reception range and save them to preset memory automatically, press and hold the /SCAN (11)
button. After the unit is finished scanning, the unit will automatically tune to preset number 1 (P01).
To tune to a preset station:
• To tune to the next preset station, press the +FOLD/+10/M. button (16).
• To tune to the previous preset, press the -FOLD/-10/M. button (24).
MANUAL PRESET MEMORY OPERATION
Choose which stations to save in preset memory instead of scanning automatically.
1. Rotate the TUNING knob (21) to tune to the station that you want to save as a preset (e.g., 93.1MHz).
2. Press the P-MODE/MEM button (23), "P01 " will flash on the display to indicate that you are saving the station as Preset Memory
01. (To change the preset memory number, press the +FOLD/+10/M. button (16) or -FOLD/-10/M. button (24))
7