Tabla de contenido
Idiomas disponibles
Idiomas disponibles
The Receiver Collar
has to be held on
top of the Boundary
Wire to activate.
The Receiver Collar
activates inside the
house.
The Receiver LED
Indicator Light is
flashing every 4 to 5
seconds and I have
just installed a new
battery.
18
• Replace battery.
• Adjust Boundary Width Control knob clockwise to
increase the distance from the Boundary Wire that
the Receiver Collar activates. Verify the Boundary
Control Switch is placed at the proper setting
according to the amount of Boundary Wire used.
• If the Receiver Collar still has to be held on top of the
Boundary Wire, refer to In-Ground Fence
and Training Guide.
• Turn the Boundary Width Control knob
counterclockwise to decrease the distance from the
Boundary Wire that the Receiver Collar activates.
• Make sure the Boundary Wire is not running within
15 feet of the house. The signal can transmit through
the walls of your house.
• Make sure Boundary Wires are twisted from
Boundary to the Fence Transmitter.
• To reset the low battery indicator, remove the battery
from the Receiver Collar. Discharge all power by
holding the correction level button down until the
LED is no longer illuminated. Reinstall battery.
1-800-732-2677
Operating
™
Tabla de contenido
