Tabla de contenido
Idiomas disponibles
Idiomas disponibles
|
BEFORE CALLING
FOR SERVICE
(continued)
Your washing
machine is equipped
with an automatic
error-monitoring
system to detect and diagnose problems at an
early stage.
Water in the washer
drains slowly or not at
all, or the
display shows:
Drain hose is kinked, pinched, or clogged.
The drain pump filter is clogged.
Make sure the drain hose is free of clogs, kinks,
etc., and is not pinched
behind or under the
washer.
Clean the drain pump filter. See Maintenance
in
the Care and Cleaning
section.
Drain discharge is more than 96 inches
Adjust or repair drain. Maximum
drain height is
above bottom of washer.
96 inches.
Washer fills with water
Water supply faucets are not open fully.
Make sure that the water faucets are fully open.
slowly
or not at all, or
"vVater line hoses are kinked, pinched,
or
Make sure the hoses are not kinked or pinched.
the display shows:
crushed.
Be careful when moving the washer during
cleaning
and maintenance
Water
inlet filters are clogged.
Clean the inlet filters. See Maintenance
in the
Care and Cleaning
section.
Water
supply pressure to faucet or house is Check another
faucet in the house to make sure
too low,
that household water pressure is adequate
and
flow is not restricted.
Water
supply connected
with leak-limiting
Hoses designed
to limit leaks can trip falsely
hoses,
and prevent the washer from filling.
The use of
leak limiting
hoses is not recommended.
..... Cycle won't start, or the
The door is not closed properly.
Make sure that the door is closed properly
and
display shows:
press the START/PAUSE button. After starting
a cycle, it may take a few moments before the
drum begins to turn or spin. The washer -will not
operate
unless the door is locked.
if the door is closed and locked and the open
door error message is displayed,
call
for service.
The display shows:
Load is too small.
Add 1or 2 similar items to help balance the load.
Load is out of balance.
The washer has an imbalance detection and
correction system. If individual heavy articles are
The display shows:
The display shows:
The display shows:
The display shows:
loaded (_th
mat, bath robe, etc.) and the imbal-
ance is too great, the washer will make several
attempts to restart the spin cycle, if an imbalance
isstill detected, the -washer will stop and the error
code will display.
Control error.
Unplug the washer and wait 60 seconds. Reconnect
power and try again. If the error reappears., call for
service.
Water
level is too high due to a faulty
Close the water faucets, unplug the washer, and
water valve,
call for service.
The water level sensor is not working
Close the water faucets, unplug the washer, and
correctly,
call for service.
A motor error has occurred.
Allow the washer to stand for 30 minutes and
then restart the cycle. If the LE error code per-
sists,call for service.
A power failure has occurred.
If the power to the washer has been interrupted
during a cycle, the PF error code will display
the next time the washer is turned ON. This will
alert you to the fact that the previous cycle may
not have been completed.
Select any cycle to
clear the error code and use the washer.
31
Tabla de contenido
