Tabla de contenido
I Once the required water temperature has been reached, turn
the dial (G) to the position that indicates the function you want
to use
In the event of difficulty...
PROBLEM / solution
WATER IS NOT SUPPLIED FROM VARIOUS FUNCTIONS
(SHOWERHEAD, VERTICAL HYDROMASSAGE, ETC.).
• Turn on the mixer tap.
THE SHOWERHEAD PROVIDES INADEQUATE PRESSURE
• Clean the filter situated between the flexible hose and the
shower head.
LITTLE WATER IS SUPPLIED FROM ALL FUNCTIONS
• Check that the plumbing system meets the pressure/capacity
specifications on the technical pre-installation data sheet.
• Check that the thermostatic valve filter is not blocked with dirt
and/or lime scale.
TH E HYD R OMAS SAG E PR OVI D E S I NAD E QUATE
PRESSURE
• Clean the nozzles. If this does not work, contact the Jacuzzi
Service Centre to check the pressure and the water system
capacity.
DIFFICULT TO ADJUST THE WATER TEMPERATURE
(MIXING)
• Check that the pressure values of the system (operating) for
hot and cold water are well-balanced. If the values are dif-
ferent, it is advisable to contact your entrusted plumber.
Maintenance
TAP FIXTURE, SHOWER PANEL
Just dry the various components after use. If it should be nec-
essary to clean them, simply remove any impurities with a soapy
wet cloth or neutral detergent, rinse with clean water and dry.
Do not use abrasive cloths, powder detergents, acetone
or other solvents.
NOZZLES (vertical hydromassage)
SHOWER HEAD
FLEXIBLE SHOWERHEAD
These components are equipped with a scale-removal filter,
which can be cleaned with a sponge. For normal cleaning oper-
ations, see instructions for taps.
CLEANING THE THERMOSTATIC VALVE
The thermostatic valve is provided with mesh filters to trap any im-
purities in the water. Over time, these filters could become
clogged and, therefore, inhibit the functions of the mixer tap. To
clean them, do the following:
A
®
I Turn off the water supply (hot and cold) to the shower enclosure.
I Drain the water from the mixing group by placing the devia-
tor ring nut (G) on the position "A - showerhead". Then set the
16
Tabla de contenido
