Setting Up The Laminator; How To Laminate; Storage & Cleaning - Fellowes Pixel A3 Manual De Instrucciones

SETTING UP THE LAMINATOR

1.
Ensure the machine is on a stable surface.
2.
Check there is enough clear space (min 50cm) behind the machine to allow
items to pass through freely.

HOW TO LAMINATE

4.
Switch the power on (located at the rear of the machine).
5.
The machine defaults to the cold setting. For 80 microns or 125 microns hot
laminating, press the once for 80 microns or twice for 125 microns.
6.
When the machine is ready, temperature setting button will stop flashing and
remain on.
7.
Place the document into the open pouch. Ensure the document is centered against
the sealed edge. Use the appropriate pouch size for the document.
NEED HELP?
Let our experts help you with a solution.
www.fellowes.com
Customer Service...
Always call Fellowes before contacting your place of purchase, see the rear cover for contact details.
TROUBLESHOOTING
Problem
No control panel illumination
Pouch does not completely seal the item
Pouch has waves or bubbles
Pouch is lost in the machine
Jamming
STORAGE & CLEANING
Switch off the machine at the wall. Allow the machine to cool. The outside of the machine can be cleaned with a damp cloth. Do not use solvents or flammable materials to
polish the machine.
Possible cause
Machine not switched on
Laminator has gone in to Auto Shut Off
mode
Item may be too thick to laminate
Temperature setting may be incorrect
Temperature setting may be incorrect
Pouch is jammed
Pouch was used 'open end' first
Pouch was not centred on entry
Pouch was not straight upon entry
Empty pouch was used
3.
Plug the machine into an easily accessible main socket.
8.
Ensure the pouch enters the machine sealed edge first. Keep the pouch straight
and central within the slot, not on an angle.
9.
Upon exit, the laminated pouch may be hot and soft. For the best quality and to
prevent jamming remove the pouch immediately. Place the pouch on to a flat
surface to cool. Take care when handling a hot pouch. Always remove laminate
pouch before starting next laminate.
10.
To release a pouch during lamination, activate the release lever located at the
rear of the machine. Gently pull pouch out of machine.
Solution
Switch on machine at rear next to plug inlet and at the wall socket
Press any button or cycle the power switch to re-start the machine
Check pass through thickness is correctly selected and pass through again
Check pouch thickness is correctly selected and pass through again
Check pouch thickness is correctly selected and pass through again
Operate the release lever and pull out the item by hand
5