Setting Up The Laminator; How To Laminate; Need Help; Storage & Cleaning - Fellowes Cosmic 2 95 Manual Del Usuario

https://www.supplychimp.com/

SETTING UP THE LAMINATOR

1.
Ensure the machine is on a stable surface.
2.
Check there is enough clear space (min 20") behind the machine to allow
items to pass through freely.

HOW TO LAMINATE

4.
Switch the power on (located at the rear of the machine).
5.
The 'Safe Start' function will automatically select the cold setting.
6.
For cold lamination, select the cold setting only.
7.
For hot lamination, choose the pouch thickness setting as required. The 'Wait'
symbol will flash during warm-up or cool-down periods.
8.
When the machine is ready, the flashing 'Wait' symbol will stop flashing and
remain on. A signal will sound.

NEED HELP?

Let our experts help you with a solution.
www.fellowes.com
Customer Service...
Always call Fellowes before contacting your place of purchase, see the rear cover for contact details.
TROUBLESHOOTING
Problem
No control panel illumination
Pouch does not completely seal the item
Pouch has waves or bubbles
Pouch is lost in the machine
Jamming
Pouch is damaged after lamination
STORAGE & CLEANING
Switch off the machine at the wall. Allow the machine to cool. The outside of the machine can be cleaned with a damp cloth. Do not use solvents or flammable materials to
polish the machine. Cleaning sheets can be used with the machine. When the machine is warm – run the sheets through the machine to clean any residue off the rollers. For
optimum performance, it is recommended that cleaning sheets are used with the machine regularly. (Cleaning sheet order codes #5320603)
Possible cause
Machine not switched on
Item may be too thick to laminate
Temperature setting may be incorrect
Temperature setting may be incorrect
Pouch is jammed
Pouch was used 'open end' first
Pouch was not centered on entry
Pouch was not straight upon entry
Empty pouch was used
Damaged rollers or adhesive on rollers
3.
Plug the machine into an easily accessible main socket.
9.
Place the document into the open pouch. Ensure the document is centered
against the sealed edge. Use the appropriate pouch size for the document.
10.
Ensure the pouch enters the machine sealed edge first. Keep the pouch straight
and central within the slot, not on an angle. Use the entry markings as a
guide.
11.
Upon exit, the laminated pouch may be hot and soft. To prevent jamming
remove the pouch immediately. Place pouch on to a flat surface to cool. Take
care when handling a hot pouch.
12.
To release a pouch during lamination, activate the release lever located at the
rear of the machine. Gently pull pouch out of machine.
Solution
Switch on machine at rear next to plug inlet and at the wall socket
Check pass through thickness is correctly selected and pass through again
Check pouch thickness is correctly selected and pass through again
Check pouch thickness is correctly selected and pass through again
Operate the release lever and pull out the item by hand
Pass cleaning sheets through the machine to test and clean rollers
5