Gaggenau DF241760 Manual De Uso Y Cuidado página 13

Adding Detergent and Rinse Agent
Opening the Detergent Dispenser
Cover
NOTE : To open the detergent dispenser
cover, press the blue release in the direction
shown in Figure 18. Pressing down on the
release tab will not open the cover.
Press
the blue
release
tab in
the
direction
shown
by the
arrow in
Figure
18.
The cover will slide open to the right.
Filling the Rinse Agent Dispenser
Open the rinse agent dispenser by pressing the
star on the cover with your index finger while
lifting the tab with your thumb as shown in Figure
19.
Figure 19
Add liquid rinse agent to the dispenser as shown
in Figure 20 until the rinse agent reservoir is full.
Wipe up any excess rinse agent that puddles
when the dispenser reservoir is full.
Figure 20
Figure 18
(continued)
Return the rinse agent dispenser cover to its shut
position and press it firmly so that the cover
snaps shut.
Refill the rinse agent dispenser when the rinse
agent reservoir level indicator "
above the numbers on the countdown display.
NOTE : After filling the rinse agent dispenser, the
" " indicator will go out in a few minutes after
the dishwasher door is shut.
Rinse Agent Dispenser Regulator
The amount of rinse agent dispensed can be
regulated to control spotting and streaking. The
Rinse Agent Dispenser Regulator as shown in
Figure 21 leaves our factory set at 4.
Figure 21
Turn dial to adjust the
amount of rinse agent
dispensed
To adjust the amount of rinse agent
dispensed:
1. Open the rinse agent dispenser cover.
2. If your glasses are streaked after washing,
turn the regulator to a lower number.
3. If your glasses are spotted after washing,
turn the regulator to a higher number.
" illuminates
11