BH FITNESS G2465 Manual De Instrucciones página 13

If the pulse rate is above the target
value the monitor will give out warning
beeps and reduce
settings by one
seconds until it reaches the minimum
1. If the pulse rate still stays above the
target value for more than 30 seconds
the monitor will beep and stop in order
to protect the user.
To program time, distance, calories
and/or pulse rate, go through the
following procedure: Once the heart
rate program has been selected and
before pressing the START / STOP
key, press the ENTER key to program
the time limit using the ▲/▼ keys.
Press ENTER again to program the
distance. Press the ENTER key one
last time to program the calories. Press
START / STOP to start the exercise.
Your hands must be placed on the
pulse sensors (R) when using these
programs.
HAND-GRIP (PULSE)
INSTRUCTIONS/USE
On this model the pulse rate is
measured by placing both hands on
the sensors (R), located on the
handlebar, as shown in Fig 3. When
both hands are placed on the sensors
the heart symbol on the right-hand
side of the screen, marked PULSE,
will begin to flash and after a few
seconds a heart rate reading will be
displayed. If both hands are not
placed correctly
function will not work.
If a "P" appears on the screen or the
heart symbol does not flash then
make sure that both hands are placed
on the sensors
connectors are connected at the back
of the electronic unit.
the exertion
level every 15
then the pulse
and that the
TELEMETRIC
(Optional).
The monitor is equipped to receive
signals from
measurement system.
The system comprises of a receiver
and a transmitter (chest band T) Fig 4.
This telemetric pulse rate system
takes precedence over the Hand-
grip pulse rate system when both
are used together.
See telemetric pulse rate instruction
book).
TEST
FITNESS
This electronic device is equipped
with a recovery test function. This
offers you the advantage of being
able to measure how long it takes
your heart rate to recover after having
finished the exercise. After finishing
the exercise leave your hands on the
pulse sensors (R) and press the
"Fitness Test" button and this will
start a one minute countdown. Only
the Time and Pulse rate function
read-outs will remain displayed. The
electronic device will measure your
pulse rate during this minute. The
heart rate recovery time will be
displayed on the Heart rate line. If, at
any time during this minute, you
decide to abandon this test then
press the "Test" button and this will
take you back to the main screen.
When the minute is up, the electronic
device will work out the difference
and your
displayed up on the screen: "F1, F2,...,
F5, F16; where F1 is the best (fitness
"Excellent") and F6 the worst (fitness
"Very Poor").
13
PULSE
a telemetric
MEASUREMENTS:
fitness rating
RATE
pulse
will be