Whirlpool W10131418A Manual Del Usario página 15

This system has been tested according to ANSI/NSF 42/53 for the reduction of the substances listed below. The concentration of
the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for
water leaving the system, as specified in ANSI/NSF 42/53.
Substance Reduction NSF Reduction
Aesthetic Effects Requirements
≥50%
Chlorine Taste/Odor
≥85%
*
Particulate Class l
Contaminant NSF Reduction
Reduction Requirements
Lead: @ pH 6.5 0.01mg/L
Lead: @ pH 8.5 0.01mg /L
Mercury: @ pH 6.5 0.002 mg/L
Mercury: @ pH 8.5 0.002 mg/L
Benzene 0.005 mg/L
p-dichlorobenzene 0.075 mg/L
Asbestos 99.0%**
‡
Cysts 99.95%
Turbidity 0.5 NTU
Endrin 0.002
O-Dichlorobenzene 0.60
Toxaphene 0.003
Ethyl Benzene 0.70
1,2,4- trichlorobenzene 0.07
Test Parameters: pH = 7.5 ± 0.5 unless otherwise noted. Flow = 0.5 gpm (1.9 Lpm). Pressure = 60 psig (413.7 kPa). Temp. = 63°F
(17.2°C).
It is essential that operational, maintenance, and filter
replacement requirements be carried out for the product to
perform as advertised.
Model WF-NLC120V: Change the water filter every
6 months. Use replacement cartridge NLC120V, part
#4396701. 2007 suggested retail price of $34.99 U.S.A./
$45.99 Canada. Prices are subject to change without notice.
The product is for cold water use only.
Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after
the system. Systems certified for cyst reduction may be used
on disinfected waters that may contain filterable cysts.
Refer to the front cover or "Accessories" section for the
Manufacturer's name, address and telephone number.
* Class I particle size: >0.5 to <1 um
** Test requirement is at least 100,000 particles/mL of AC Fine Test Dust.
†
These contaminants are not necessarily in your water supply. Performance may vary based on local water conditions.
††
Fibers greater than 10 um in length
‡
Based on the use of Cryptosporidium parvum oocysts
® NSF is a registered trademark of NSF International.
Base Grille Water Filtration System
Model WF-NLC120V Capacity 120 Gallons (454 Liters)
System tested and certified by NSF International against NSF/ANSI Standard 53 for the
reduction of Lead, Mercury, Benzene, p-dichlorobenzene, Cysts, Turbidity, Asbestos,
Endrin, O-Dichlorobenzene, Toxaphene, Ethyl Benzene, 1,2,4-trichlorobenzene and against
NSF/ANSI Standard 42 for the reduction of Chlorine Taste and Odor and Particulate Class I.
Average Influent Challenge
Influent Concentration
1.9 mg/L 2.0 mg/L ± 10%
5,300,000/mL At least 10,000 particles/mL
Average Influent Challenge
Influent Concentration
†
0.14 mg/L 0.15 mg/L ± 10%
†
0.15 mg /L 0.15 mg /L ± 10%
0.0058 mg/L 0.006 mg/L ± 10%
0.0055 mg/L 0.006 mg /L ± 10%
0.0153 mg/L 0.015 mg/L ± 10%
0.215 mg/L 0.225 mg/L ± 10%
7 7
842 x 10 10 to 10
165,500/mL 50,000/L min.
11.75 NTU 11 ± 1 NTU
0.0056 0.006 ± 10%
1.84 1.8 ± 10%
0.0143 0.015 ± 10%
2.00 2.1 ± 10%
0.232 0.21 ± 10%
Maximum
Effluent
0.12 mg/L
50,000/mL**
Maximum
Effluent
0.001 mg/L
0.001 mg/L
0.0005 mg/L
0.0013 mg /L
0.0036 mg/L
0.0037 mg/L
††
8 7
fibers/L 1.6 x 10 mg/L 1.6 x 10
1 mg/L
0.38 NTU
0.0007
0.33
0.001
0.60
0.0025
Refer to the "Warranty" section for the Manufacturer's limited
warranty.
Application Guidelines/Water Supply Parameters
Water Supply
Water Pressure
Water Temperature
Service Flow Rate
Average Minimum%
Effluent Reduction
0.08 mg/L >75%
15,725/mL 99.0%
Average Minimum%
Effluent Reduction
0.001 mg/L 99.29%
0.001 mg/L 99.32%
0.0003 mg/L 91.37%
0.0005 mg/L 76.36%
0.0014 mg/L 76.47%
0.0010 mg/L 98.27%
7
mg/L 99.81
1 mg/L 99.99%
0.22 NTU 96.76%
0.0004 87.50
0.071 82.06
0.001 93.00
0.169 70.00
0.0007 98.92
City or Well
30 - 120 psi (207 - 827 kPa)
33° - 100°F (0.6° - 37.8°C)
0.5 GPM (1.89 L/min.) @ 60 psi.
Average%
Reduction
>75%
99.7%
Average%
Reduction
99.29%
99.32%
94.82%
90.90%
90.84%
99.52%
99.81%
99.99%
98.12%
92.85
96.14
93.00
91.55
99.69
15