Testing Your Fan - Craftmade ELLINGTON LAVH44BNK4 Guia De Instalacion

10. Testing Your Fan.

It is recommended that you test fan before
finalizing installation. Restore power from
circuit box and light switch (if applicable).
Test fan speeds with the pull chain labeled
SPEED. Start at the OFF position (no blade
movement). First pull will set the fan to HI.
Second pull will set the fan to MEDIUM.
Third pull will set the fan to LOW. Fourth pull
will again set the fan to the OFF setting. Test
light with the pull chain labeled LIGHT.
(diagram 1) If fan and/or light do (does) not
function, please refer to "Troubleshooting"
section to solve any issues before
contacting Customer Service.
Turn fan completely off before moving the
reverse switch (located on light kit fitter).
Set reverse switch to recirculate air
depending on the season:
- LEFT position in summer
(diagram 2)
- RIGHT position in winter
(diagram 3)
A ceiling fan will allow you to raise your
thermostat setting in summer and lower
your thermostat setting in winter without
feeling a difference in your comfort.
Important: Reverse switch must be set
either completely LEFT or completely RIGHT
for fan to function. If the reverse switch is
set in the middle position (diagram 4), fan
will not operate.
Attach pull chain extensions supplied or
custom pull chain extensions (sold
separately) to ends of the pull chains.
light
pull chain
extension
diagram 1
diagram 2
page 7
motor housing
reverse switch
diagram 3 diagram 4
light kit
fitter
fan
pull chain
extension