Troubleshooting - Toro 20601 Manual Del Operador

Troubleshooting

Problem
Roller does not turn.
Patterning effect does not show.
U-Bar assembly is hitting the ground.
Possible Cause
1. Debris stuck in roller assembly
2. Roller plug is not fully tightened.
3. Roller assembly is not filled.
1. Lawn striper is not attached correctly
2. Grass is cut too short.
3. Lack of proper sunlight.
1. Assembly is not at proper height.
2. Height is different on either side of
assembly.
5
Corrective Action
1. Turn off mower and verify/remove any
debris (bark, twigs, stones) that are
obstructing the roller.
2. Check to see that roller plug is flush
with end cap, and tighten roller plug
fully.
3. Make sure the roller assembly is filled
with approximately 16 to 20 lbs. of
DRY sand.
1. Refer to Owner's Manual for proper
installation.
2. Wait for grass to grow before cutting
with the lawn striper attached.
3. Partial/full sunlight is optimal.
1. Turn off the mower, and set assembly
to proper height and angle as outlined
in Owner's Manual.
2. Make sure that height is the same
on both sides as outlined in Owner's
Manual.