Service Access - Jacuzzi Espree Serie Manual De Instalación Y Operación

Service Access

For partially or fully sunken installations, allow for
access to service connections. It is the installer's re-
sponsibility to provide sufficient service access. The
recommended minimum dimensions allowable for
service to the bath are shown in the "Service Access
- Without Skirt" illustration.
Provide adequate area around unit for air circulation
for cooling the motor and to supply sufficient air to the
jets. Do not insulate this area or around motor.
Service Access (Corner bath without skirt)
18"
C
36"
RIgHt HaND UNIt SHoWN
a - Preferred access
B - acceptable alternative if access a is not possible
C - optional access for accessory equipment
Note: Left hand unit access is on the opposite side (mirror image)
SERVICE ACCESS
(WITHOUT SKIRT)
FRONT
ALTERNATE
ACCESS
12"
18"
Optional RapidHeat
TM
Where tubs have been ordered with the optional Rapid-
Heat heater consider an additional service access.
tM
If service access has not been provided, it is the
home owners responsibility to remove the bath and
provide the required access, should a repair become
necessary.
Copyright © 2007 by Jacuzzi Whirlpool Bath
INSTALLATION
Control
Panel
20"
B
A
24"
MOTOR
12"
18"
PREFERRED
ACCESS
Service Access
Service Access with Skirt
An optional skirt fits along the side of the bath for
above-floor installations and is also an access panel for
servicing. allow a space of at least 8 inches (203 mm)
away from the bath for skirt removal.
the skirt is designed to accommodate the added
height of the tile, linoleum, or other floor coverings up to
1-1/4 inches (32 mm) above the floor, and will be flush
with the floor when installed.
More detailed instructions on skirt installation are
provided with the optional skirt assembly.
Service Access with Integral Skirt
Service access is through the removable skirt
panel.
Removable Skirt Panel
Removal and Installation
to remove panel, grab a top corner of access panel
and pull outward to release the first of six fasteners.
then work around the perimeter pulling the access panel
outward to release the remaining fasteners.
To reinstall, align access panel such that the six
fasteners on the access panel match to the six fasteners
on the tub skirt. engage each pair of fasteners until all
are firmly in place.
11
Removable
skirt panel
top corner
of panel
Motor
access
area
Remove
panel
U961000K 06/07