Tabla de contenido
SERVICING TWO SPEED WINCHES 30ST, 40ST, 44ST, 48ST, 50ST, 54ST, 58ST & 64ST
1
4
7
10
Page 40
2
5
8
11
3
6
9
12
1. Unscrew top cap.
2. Lift and remove the feeder arm.
3. Remove the two retaining collets, lift out the main
spindle.
4. Remove and clean the drum bearings and washer.
5. Using Lewmar winch grease, lightly grease the
gear ratchets and internal bearing surfaces.
Reassemble the gears.
6. Lift out the gear spindles and remove the gear
assemblies.
7. Remove and inspect the pawls and pawl springs,
replace if necessary.
8. Assemble the pawls and springs, lightly oil the
pawls, check for correct operation (no sticking).
9. Lightly grease the ratchet and bearing surfaces,
reassemble the gears.
10. Lightly grease and fit the gears, gear spindles and
the main spindle.
11. Strip and clean crown assembly. See the Servicing
Wavespring section in this manual.
12. Reassemble the drum, main spindle retaining
collets and feeder arm. Lightly grease the 'O' ring
and top cap thread before fitting.
Page 41
Tabla de contenido
