Hydraulic Oil - ATIKA ASP 10 N - 400 Manual Original

5.
Insert the seal and drain plug again.
6.
Pour in the new hydraulic oil (approx. 5.5 litres) using a
clean funnel.
7.
Clean the dipstick and the oil seal.
8.
Check the oil seal and replace it if it is damaged in any way.
9.
Replace the dipstick.
Dispose of the old oil properly (local oil disposal point). The
old oil must not be poured into the ground or drainage
system, or mixed with other waste.
T e c h n i c a l d a t a
T e c h n i c a l d a t a
Model / Type
Year of construction
Splitting force
Log length
Log diameter
Stroke
Feed speed
Return speed
Hydraulic oil (max.)
Hydraulic pressure
Electric motor performance (power consumption)
Power supply
Dimensions
Weight


Hydraulic oil

We recommend the following hydraulic oils for the hydraulic
cylinder:
 Shell Tellus T 22
 Aral Vitam Gf 22
 BP Energol HLP 22
 Mobil DTE 11
 or equivalent
Do not use any other types of oil. The use of any other type
of oil will adversely affect the operation of the hydraulic
cylinder.
S t o r a g e
S t o r a g e
Before each storage:
 Retract the splitting cross.
 switch off device
 Close the oil cap.
 Pull out mains plug.
Store machines that are not in use in a dry locked place protected
against frost and outside the reach of children and unauthorized
persons.
Before extended storage, please observe the following to
increase the service life of the device and to ensure smooth
operation:
 thoroughly clean the device.
 Check the device for damaged or worn parts.
lubricate the splitting column regularly or oil it using
environmentally friendly spray oil.
ASP 10 N – 400
see last page
100 kN (10 t)
max. 1300 mm
min. 120 mm – max. 400 mm
 525 mm
approx. 0.05 m/sek.
approx. 0.25 m/sek.
10 litres
21 MPa (210 bar)
P 4.0 kW S6 (4 min/6 min)
1
400 V / 3N~+PE 50 Hz, 16 A
length 580 x width 530 x height 1530 mm
approx. 175 kg
29