Bosch RC 1 Professional Manual Original página 14

OBJ_BUCH-934-005.book Page 14 Wednesday, June 8, 2016 9:48 AM
14 | English
Rotational Operation
-1
(150/300/600 min
The function of the button for rotational operation 1 on the remote control is identical
with that on the rotational laser.
Each time after switching on, the rotational laser is in rotational operation mode with
average rotational speed.
To switch from line operation to rotational operation, press the rotational operation
button 1. Rotational operation starts with average rotational speed.
To change the rotational speed, press the rotational operation button 1 again until the
requested speed is reached.
Line Operation, Point Operation
(10°/25°/50°, 0°)
The function of the button for line operation 2 on the remote control is identical with
that on the rotational laser.
To switch to line or point operation, press the line operation button 2. The rotational
laser switches to line operation with the smallest aperture angle.
To change the aperture angle, press the line operation button 2. The aperture angle is
increased in two steps; at the same time, the rotational speed is increased with each
step. When pressing the line operation button 2 a third time, the rotational laser
switches to point operation after brief post-pulsation. Pressing button 2 again takes
you back to line operation with the smallest aperture angle.
Note: Due to inertia, it is possible for the laser to slightly move beyond the end point
of the laser line.
Rotating the Laser Line/Laser Dot or the Rotational Plane
(see figure A)
Rotating the laser line/laser dot or the rotational plane is possible only with the re-
mote control.
When the rotational laser is in the horizontal position, the laser line (in line opera-
tion) or the laser dot (in point operation) can be positioned within the rotational plane
of the laser. Rotation is possible by 360°.
Press button 4 to rotate in clockwise direction, and button 5 to rotate in anticlockwise
direction. In rotational operation, pressing the buttons has no effect.
When the rotational laser is in the vertical position, it is possible to rotate the laser
point, laser line or rotational plane around the vertical axis. Rotating is possible only
within the self-levelling range (5° toward the left or right).
1 609 92A 27C | (8.6.16)
)
Bosch Power Tools