Kohler THE BOLD LOOK K-T6808 Guia De Instalacion página 7

Valve Stem
Faceplate
Discard plaster
guard with dome.
Centering Washer
Screws
4. Install the Faceplate and Lever Handle
CAUTION: Risk of product damage to the K-306–KS valve
assembly. When using this valve in a fiberglass or acrylic
installation, use the Thin Wall Installation Kit (88526).
Remove and discard the plaster guard and/or dome, if installed.
Fit the faceplate and centering washer over the valve, and secure
with two screws.
Rotate the valve stem fully counterclockwise.
Lever Handle
Fit a sleeve and bonnet over each stem adapter.
Thread a bonnet to each valve body until they are tight against
the escutcheon.
Install a center cap to each bonnet.
Fit a long sleeve to each handle arm, and secure it with the end
cap.
Insert a handle arm through each center cap and bonnet.
Install a short sleeve and washer onto each handle arm and
secure them with the end cap.
Kohler Co.
Valve Stem
Sleeve
End Cap
Short Sleeve
Bonnet
O-Ring
Center Cap
Long Sleeve
Handle Arm
7
Washer
Screw
114498-2-E