Bosch AXT Rapid 2000 Manual Original página 11


Keep your face and body away from
the chute assembly.
 Do not allow hands or any other part
of the body or clothing inside the
chute assembly, discharge chute or
near any moving part.

Keep proper balance and footing at all
times. Do not overreach. Never stand
at a higher level than the base of the
machine when feeding material.

Always stand clear of the discharge
zone when operating the machine.
 When feeding material into the ma-
chine be extremely careful that pieces
of metal, rocks, bottles, cans or other
foreign objects are not included.
 If the cutting mechanism strikes any
foreign object or if the machine
should start making any unusual
noise or vibration, immediately
switch off and allow the cutter to
stop. Remove the plug from the
mains supply and take the following
steps:
– Inspect for damage.
– Replace or repair any damaged
parts.
– Check for and tighten any loose
parts.

Do not attempt to repair the machine
unless you are qualified to do so.
 Do not allow processed material to
build up in the discharge zone; this
may prevent proper discharge which
can result in kickback of material
through the chute assembly.

If the machine becomes clogged,
switch off and allow the cutter to
stop. Remove the plug from the
mains supply before clearing debris.
Bosch Power Tools

Check if guards and protective devic-
es are undamaged and properly
mounted. Before using, carry out any
necessary maintenance and repairs.
 Do not tamper with the motor speed
control settings. Contact a Bosch ap-
proved service agent if a problem ex-
ists.
 Keep the motor cooling vents clean of
debris and other accumulations to
prevent damage to the motor or pos-
sible fire.

Never pick up or carry the machine
while the motor is running.
 Switch off, allow the cutter to stop
and remove the plug from the mains
supply whenever you leave the work
area.
 Do not tilt the machine while it is run-
ning.
 Do not expose the machine to rain.
Only store the machine in a dry place.
Maintenance and Storage
 When the machine is stopped for ser-
vicing, inspection, or storage, or to
change an accessory, switch off and
remove the plug from the mains sup-
ply and allow the machine to cool.
Make sure that all moving parts have
come to a complete stop before mak-
ing any inspections, adjustments,
etc.

Maintain the machine with care and
keep it clean.
 Examine the machine and replace
worn or damaged parts for safety.
 Ensure replacement parts fitted are
Bosch approved.
English | 11
F 016 L81 148 | (22.10.14)