Cleaning And Maintenance; Cleaning The Cabinet - Tripp-Lite SRCOOL12K El Manual Del Propietario

Operation
Changing Degree Units
The unit can display temperature in both Celsius and Fahrenheit. The default setting for the
SRCOOL12K is Fahrenheit and the SRXCOOL12K, SRXCOOL12KA and SRXCOOL12KB are
Celsius.
To toggle between temperature modes, put the unit in standby mode. The air conditioner
is in standby mode when it is plugged into live AC power, but powered off. Then, hold the
"FUNCTION" key for 10 seconds. To verify the degree units have changed, power on the unit.
Alarm
When the water tank is full, the unit will display the message "E4" on its screen. To resume
normal function, turn the unit off, remove the drainage plug and drain the excess water from
the unit. Replace the plug and turn the unit on to begin cooling.

Cleaning and Maintenance

Clean the air conditioner and clean or replace the filters regularly to maximize performance and efficiency, prolong the unit's life, and qualify for
warranty if there is a performance issue.
Note: Always unplug the air conditioner from the power outlet before cleaning.
Cleaning the Air Filters
It is important to keep the air filters clean and free of dust. When the filters are dirty or clogged with dust, it decreases cooling efficiency and can
threaten air quality. Tripp Lite recommends cleaning the filters at least once every two weeks. If the unit is used in a dusty environment, the filters
may need to be cleaned or replaced weekly.
Before cleaning the filters, turn the unit off and unplug it! There is a risk of electric shock while the unit is plugged in.
Never run the cooling unit without the filter.
1. Turn the unit off and unplug it.
2. Remove the filters by sliding them out of the cabinet.
A
3. Use a vacuum cleaner or tap the filter lightly to remove loose dust and dirt.
4. Wash the filters in warm water with a neutral detergent. Do not put the filters into a
dishwasher or use harsh detergents or chemicals. Allow the filters to air dry completely after
washing.
Note: Do not use water hotter than 104° F (40° C) to clean the filters.
5. Replace the filters by sliding them back into their original position.
6. Plug the unit in and resume normal operation.

Cleaning the Cabinet

Before cleaning the cabinet, turn the unit off and unplug it! There is a risk of
electric shock while the unit is plugged in.
1. Turn the unit off and unplug it.
2. Use a dry, non-abrasive cloth to wipe the cabinet. If necessary, use lukewarm water to
dampen the cloth. Never use abrasive chemicals, volatile substances, gasoline, benzene,
thinners, detergents, chemically treated cloths, or other harsh chemicals or cleaning solvents
that may damage the cabinet exterior. Do not pour water directly over the unit or into the
working parts. This causes a risk of electrical shock and deterioration of electrical components and wiring insulation.
3. Use a soft bristle brush to clean between the vents.
4. Carefully use a vacuum cleaner to clean the condenser coils.
10
A
A