Tabla de contenido
Idiomas disponibles
Idiomas disponibles
LOADING THE TOOL (FIG. 1–4)
Keep the tool pointed away from
yourself and others. Serious personal injury may
result.
Never load nails with the contact trip
or trigger activated. Personal injury may result.
1.
Read all Safety Warnings before using tool.
2.
Connect the air supply to the tool.
3.
Insert fasteners (L) into T-slot (K) on end cap
of magazine (J) past the nail stop (E). NOTE:
Magazine will hold two full fastener strips.
4.
Pull pusher (I) back until the nail stop (E) falls behind the fasteners.
NOTE: Do not allow the pusher to snap forward against the nail strip, allowing this
to happen could damage the nail collation.
Fig. 3
ACTUATING TOOL
To reduce the risk of injury, ALWAYS wear proper eye ANSI Z87.1
(CAN/CSA Z94.3) and hearing protection ANSI S12.6 (S3.19) when operating this
tool. The tool can be actuated using one of two modes: single sequential actuation
trigger mode and contact actuation trigger mode.
Sequential actuation trigger (gray) -
Allow the tool to recoil off the work surface after actuation. If the
contact trip remains depressed a nail will be driven each time the trigger is
released and pulled, which could result in accidental actuation, possibly causing
injury.
The sequential actuation trigger's intended use is
for intermittent fastening where accurate fastener
placement is desired.
To operate the tool in sequential actuation
mode:
1.
Depress the contact trip firmly against the
work surface.
2.
Pull the trigger.
3.
Allow the tool to recoil from the work surface.
L
E
Fig. 2
Fig. 4
(Fig. 5)
Fig. 5
9 - ENG
L
K
E
J
I
H
L
Gray - sequential
Tabla de contenido
