Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Always disconnect air line from tool and remove fasteners
from magazine before making adjustments or personal injury may result.
DAILY MAINTENANCE CHART
ACTION
Lubricate tool with
5-7 drops of
non-detergent SAE 20
weight pneumatic tool oil.
Drain compressor
tanks and hoses daily
or after each use.
Clean magazine,
magazine release and
contact trip mechanism.
Before each use, check
to insure all screws,
nuts and fasteners are
tight and undamaged.
CLEANING
Never use solvents or other harsh chemicals for cleaning the non-
metallic parts of the tool. These chemicals may weaken the materials used in these
parts. Use a cloth dampened only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool into a liquid.
REPLACEMENT PARTS
Use only identical replacement parts. Refer to your Parts List for replacement part
numbers. You can order parts from your nearest Stanley Black & Decker Factory
Service Center or Authorized Warranty Service Center. Or, you can call our Customer
Care Center at 1-888-848-5175 (U.S. & Canada Only).
SERVICE AND REPAIRS
All quality tools will eventually require servicing and/or replacement of parts. For
information about Stanley Black & Decker Factory Service Center or Authorized
Warranty Service Centers call our Customer Care Center at 1-888-848-5175 (U.S.
& Canada Only). All repairs made by our service centers are fully guaranteed
against defective material and workmanship. We cannot guarantee repairs made or
attempted by others.
MAINTENANCE
WHY
Prevents failure
of o-rings.
Prevents
accumulation
of moisture in
compressor
and nailer.
Permits smooth
operation of
magazine,
reduces wear and
prevents jams.
Prevents jams, leaks
and premature
failure of tool parts.
SERVICE
13 - ENG
HOW
Insert drops into air fitting
on end cap of tool.
Open petcocks or other drain
valves on compressor tanks.
Allow any accumulated
water to drain from hoses.
Blow clean with compressor
air. The use of oils, lubricants
periodically or solvents is
not recommended as they
tend to attract debris.
Tighten loose screws
or other fasteners using
the appropriate hex
wrench or screwdriver.
Tabla de contenido
