How To Use - Vornado 183 Guia Del Propietario

How To Use

POWER (A) The unit functions ON and OFF by pressing the POWER
button. Lights on the unit's control panel indicate the power is ON.
FAN SPEED (B) The fan speed can be adjusted by pressing the SPEED
button. Press the button to switch between the unit's speed settings. The
turbo (highest) setting is for maximum air circulation. Lights on the unit's
control panel indicate the selected speed setting.
TIMER (C) The unit has an automatic timer to turn the unit OFF at intervals
of 1, 2, 4 or 8 hours (hrs). To set the timer, turn the unit on at the desired
speed, press the timer button until the desired run time light is illuminated.
The unit will continue to run until that amount of time has expired.
POWER (A)
FAN SPEED (B)
TIMER (C)
Model 184 (pictured above) features 4 speed settings (I,II,III,IIII)
Model 183 features 3 speed settings (I,II,III)
6 English
www.sylvane.com 1-800-934-9194
REMOTE CONTROL This unit comes with a remote control. The remote
control functions are the same as the control panel on the unit. The remote
requires a line-of-sight path to allow for the signal to be received by the unit.
Position the unit so the receiver lens is visible from the remote control. The
remote control can be stored with the Tower Circulator using the magnetic
bowl-shaped cradle located on the top of the product.
REMOTE CONTROL BATTERY The remote control comes with a 3 Volt
lithium coin cell battery (CR2032). To install, remove the battery cover on the
bottom of the remote control. Remove any plastic protection from the battery
and place it in the remote with the + side facing out. Then reposition the
cover onto the bottom of the remote. If your remote no longer works, please
try replacing with a new 3 Volt CR2032 battery.
Figure C.
REMOTE CONTROL
B
A C
How To Use
1. Position your Tower Air Circulator so the air-stream has an
unobstructed path from one side of the room to the other,
or position the air-stream to blow directly at you for direct
cooling. Note: The Vornado logo indicates the center point
of the V-Flow™ airstream, and can be used as a reference
point for positioning the product in the room. See Figure C.
2. Set to a medium speed and allow a few minutes for an
airflow pattern to be established. (Different airflow patterns
can be established by changing the location, and speed of
the Air Circulator.)
3. Adjust the speed accordingly until a desired comfort level
is achieved. You will quickly determine the precise amount
of circulation required to maintain your personal comfort in
a given room for the prevailing temperature and humidity
conditions. Once you discover the added comfort of air
circulation, you will use your Vornado Tower Air Circulator
season after season.