Maintenance Instructions; Moving And Storage Instructions - Schumacher Electric PBI1812 El Manual Del Propietario

Ocultar thumbs Ver también para PBI1812:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 24
7.3
Powering a 12V DC Device:
The booster is a power source for all 12V DC accessories that are equipped with a 12V
Make sure the device to be powered is OFF before inserting the 12V DC accessory plug
into the 12V DC accessory outlet.
1. Open the protective cover of the DC power outlet on the front of the booster.
2. Plug the device into the outlet and turn the device on (if required).
3. If the device draws more than 15A or has a short circuit, the internal circuit breaker
of the booster will trip and disconnect the power to the device. Disconnect the device
and the breaker will automatically reset.
IMPORTANT
operation of a 12V device may result in excessive battery drain. Recharge immediately
after unplugging the device.
8.
FUSE REPLACEMENT FOR THE BOOSTER
The Portable Power is equipped with an inline fuse, to protect the battery from overload.
Fuse Speci cation
Fast blow, DC automotive type, rated 32 V, 300 A (Buss AMG-300).
WARNING
1. Allow the fuse to cool down completely (approximately 5 minutes).
2. Make sure the switch is in the OFF position and the unit is unplugged from
3. Remove the positive (RED) clamp from the side of the unit and locate
4. Open the fuse holder by removing its cover.
5.
Repeat the same steps for the second nut and bolt. Remove the open fuse and replace
it with a new one of the same type and rating.
6. Tighten the nuts and bolts to secure the fuse, and then replace the cover of the
fuse holder.
7. The unit is now ready to use.
9.

MAINTENANCE INSTRUCTIONS

9.1
Unplug the charger from the booster before attempting any maintenance or cleaning.
9.2
Use a dry cloth to wipe all battery corrosion and other dirt or oil from the battery clamps,
9.3
Ensure that all of the booster components are in place and in good working condition.
9.4
10.

MOVING AND STORAGE INSTRUCTIONS

10.1
Store the booster in an upright position, inside, in a cool, dry place.
10.2
Always make sure the booster is fully charged before storing. When not using it for long
periods of time, recharge the booster every 30 days.
IMPORTANT
damage could occur if the internal battery should unexpectedly leak acid.
The DC power outlet is wired directly to the internal battery. Extended
the external charger.
the fuse holder.
Do not use and/or store the booster in or on any area or surface where
6
Tabla de contenido
loading

Tabla de contenido