Operating Instructions - Kapro 883N Prolaser 3D All- Lines Manual Del Usuario

Working in Automatic mode (self-leveling):
In automatic mode the laser level will level itself in the range
of ± 3.5° and will project 1 horizontal 360° or/and 2 vertical
360° red beams.
1. Remove the laser from the case and place it on a solid, flat
vibration free surface or on a tripod.
2. Push the locking switch #1 to the ON position. The laser
level will project a 360° horizontal beam.
3. Press the lines button switch #2 this will switch off the
horizontal beam, and it will project a 360° vertical side beam.
4. Additional click on the lines button switch #2 will switch off
the side vertical beam, and will project forward a 360°
vertical beam.
5. Additional click on the lines button switch #2 will add the
side vertical beam.
6. Additional click on the lines button switch #2 will add the
horizontal beam.
7. Additional click on the lines button switch #2 will switch off
the 2 verticals beams.
8. If the initial level of the laser is beyond ± 3.5°and the
automatic mode is activated the laser beams will flash. In
this case reposition the laser on a more level surface.
9. Before moving the laser level push back the locking switch
#1 to the OFF position this will lock the pendulum, and
protect your laser.
10

OPERATING INSTRUCTIONS