Vacuum Controls - Hoover PLATINUM COLLECTION CYCLONIC BAGLESS CANISTER El Manual Del Propietario

4. HOW TO OPERATE
NOTE: Operate cleaner only at voltage specified on
the data plate on the underside of the cleaner.
Vacuum Contro ls
H andle/Hose Grip
1 Pow er B ut t o n
Push to turn cleaner on and off.
2 B r us hr o l l O n /O f f B u t t o n
Push to turn Brushroll on and off.
3 S uc ti o n Co nt r o l Va l v e
To clean delicate fabrics, slide the Suction
Control Valve to the open position to lower
the suction.
Slide as shown to open and close the Valve.
N oz zle
4 Fl o o r S el ec t o r Pe d a l
Push the Floor Selector Pedal to raise and lower the Nozzle
to clean bare floors and various carpet pile heights. For maxi-
mum cleaning performance, the following carpet height settings are
recommended:
• Low and Medium settings: for low to medium pile carpets.
• High setting: for very deep pile carpet where easier
pushing effort is desired,while maintaining good cleaning
performance.
NOTE: If the cleaner is difficult to push, change floor selector
push button to the next highest setting.
NOTE: In Bare Floor mode brushroll will automatically shut off.
5 F l o or S e l e c t o r I n d ic a t o r Li gh t
Indicates the carpet height selected by the Floor Selector Pedal.
4.3 4.4
7
1
3
2
6 Handle Release Pedal
Step on the Handle Release Pedal to lower hand grip into
cleaning position.
NOTE: Brushroll will not run until handle is released.
7 Reset Bu tton
This power nozzle is equipped with an electrical reset button.
If the brushroll is jammed, the rest button will automatically
shut off the brushroll motor. If this happens, unplug cleaner
and clear jam from brushroll. Press the reset button, plug in
the cleaner and resume use.
Ind icator Li g ht
FLOOR SELECTION
Very High Pile Carpets.
Low to Mid Pile Carpets.
Bare Floors.
(Brushroll off)
4
5
6
9