Secondary Function Button; Calibration Button; Ma (Μc) Up (21) And Down Buttons (23 - Organon TOF-Watch SX Manual Del Usuario

4.1.2

Secondary function button (4)

short:
If this button is pressed prior to a button with a secondary function (description
above the button), the secondary function is carried out instead of the primary
function. This is indicated by the
buttons are activated within 5 s after pressing the secondary function button, the
TOF-Watch automatically reverts to primary mode.
long:
By pressing this button for more than 1 s the stimulation beep is toggled on and
off and the
Note: If the stimulation beep is switched on, a short beep can be heard each time the
TOF-Watch performs a stimulation. When not desired, be sure to switch off the
stimulation beep in cases where beeps from other operating equipment are more
important (e.g. heart monitoring systems).
4.1.3

Calibration button (22)

long:
Notes: Calibration is only possible when the
If
is either too low or too unstable.
Selection of one of the two different built-in calibration sequences can be made in
the set-up menu (see Set-up menu on page 16).
4.1.4 mA (µC) up (21) and down buttons (23)
short:
long:
(µ (
If both up and down are activated simultaneously, the set-up mode is entered.
See page 16 for more information.
11 | TOF-Watch SX Operator manual 33.512/A
Activation of secondary function mode.
Activation / deactivation of stimulation beep.
(10) symbol is showed for 1 s (see also Set-up menu on page 16).
Starts calibration (adjust gain to 100% control twitch
height) or returns to standard gain.
flashes after completion of calibration the acceleration transducer signal
Stimulation strength is shown in display, or if already
shown stepped up or down.
Stimulation strength is continuously stepped up or down.
mA
symbol on the display. If no stimulation
symbol is shown in the display.
µC