Tailgate Handle Camera for select GM Trucks (2007-2013) Chevrolet / GMC
Installation Guide
Factory Tailgate handle surround removal
1
Lower the tailgate to open position and remove lower access
cover by removing (4) Torx T27.
2
Remove one M8 x 25mm using a 13 mm socket. (Remove the
lowest of the (3) bolts which are a triangle pattern see illustration
below.
3
Disengage the (3) clips on factory surround locations shown below
and remove the tailgate handle cover from the outside of the tailgate.
The handle will remain in place only the surround will be removed.
1
4
5
6
2
3
With the handle surround completely removed, route all wires
from tailgate handle camera through to the lower access cover.
Not used for
HCE-TG130GM
Snap in the handle surround and engage the (2) clips to hold it in
place. Only (2) clips are used and M6 bolt for 3rd attachment point.
Use the M6 x 25 mm machine screw with lock and flat washer to
bolt in the handle surround.
˜ 7/11
