Idiomas disponibles
Idiomas disponibles
1. Remove the engine oil filter, and fill with clean engine oil.
2. Install the oil filter and tighten.
3. Locate and remove the engine block left front oil gallery
plug (1).
4. Install the M16 x 1.5 adapter P/N 509375 J 45299 Engine
Preluber.
5. Install the flexible hose to the adapter and open the valve.
LS9 Crate Engine
TITLE
ALL INFORMATION WITHIN ABOVE BORDER TO BE PRINTED EXACTLY AS SHOWN ON 8 1/2 x 11
WHITE 16 POUND BOND PAPER. PRINT ON BOTH SIDES, EXCLUDING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE WITH GM SPECIFICATIONS.
6. Pump the handle on the J45299 preluber in order to flow
a minimum of 1-1.9 liters (1-2 quarts) engine oil. Observe
the flow of engine oil through the flexible hose and into
the engine assembly. The engine will be primed after
a small amount of pressure change is seen on the in car
oil pressure gauge while pumping J45299.
7. Close the valve and remove the flexible hose and adapter
from the engine.
8. Apply approved thread sealer and Install the oil gallery plug
to the engine and tighten to 60 N•m (44 lb ft).
Top-off the engine oil tank to the proper level.
3. Start the engine and listen for any unusual noises. If no unusual
noises are noted, run the engine at approximately 1000 RPM
until normal operating temperature is reached.
4. When possible, you should always allow the engine to warm
up prior to driving. It is a good practice to allow the oil sump
and water temperature to reach 180°F before towing heavy
loads or performing hard acceleration runs.
5. The engine should be driven at varying loads and conditions
for the first 30 miles or one hour without wide open throttle
(WOT) or sustained high RPM accelerations.
6. Run five or six medium throttle (50%) accelerations to about
4000 RPM and back to idle (0% throttle) in gear.
7.
Run two or three hard throttle (WOT 100%) accelerations to
about 4000 RPM and back to idle (0% throttle) in gear.
8. Change the oil and filter. Replace the oil per the specification
in step 1, and replace the filter with a new UPF48R AC Delco
oil filter. Inspect the oil and the oil filter for any foreign particles
to ensure that the engine is functioning properly.
9. Drive the next 500 miles (12 to 15 engine hours) under normal
conditions. Do not run the engine at its maximum rated engine
speed. Also, do not expose the engine to extended periods
of high load.
10. Change the oil and filter. Again, inspect the oil and oil filter for
any foreign particles to ensure that the engine is functioning
properly.
19244099
REV 06JN16
PART NO.
DATE
4
SHEET
REVISION
17
OF
AUTH
