Notch Sentinel Manual Del Usuario página 9

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

LIFESPAN AND REPLACEMENT:
The lifespan of the product will depend on frequency of use and
external conditions. This product is made from synthetic fibre
(polyamide, polyester, aluminium alloy, steel). Part of these
components degrade over time. Seven years is considered the
safe life of nylon climbing equipment when it is stored properly
and never used.
WHEN TO RETIRE THE EQUIPMENT:
A product must be retired when:
•It's over 10 years old and made of plastic or textiles
•It has been subjected to a major fall (or load)
• It fails to pass inspection. You have any doubt as to its
reliability
•You do not know its full usage history
• When it becomes obsolete due to changes in legislation,
standards, technique, or incompatibility with other equipment
STORAGE:
Store in a clean, cool, dark, place free of acids, alkalis, exhaust
emissions, rust and strong chemicals. Store without
mechanical stress caused by jamming, pressure or tension.
TRANSPORT:
The product must be transported to avoid direct sunlight,
moisture, chemicals, dirt, extreme temperatures and
mechanical damage.
CLEANING:
Clean soiled products in luke warm water (if necessary, use pH
neutral soap). Rinse well. Hang dry at room temperature in well
ventilated area out of direct sunlight, never use a tumble dryer.
If required, halogen-free commercial disinfectants may be
used.
Metal hardware parts (anchor plates, buckles, etc.) should be
cleaned and dried. If necessary, minor sharp edges may be
polished using a fine abrasive cloth before cleaning.
Periodic lubrication of metal hardware using a lightweight
lubricant will maintain smooth operation, wipe off any excess
lubricant with a clean dry cloth.
WARNINGS FOR ROPE BRIDGE:
Rope bridge attached to this harness is designed to be replaced
by the user at regular intervals. Interval will be dictated by the
frequency of use and external working conditions rather than
set time.
Manufacturer does not place a time limit on the replacement
of the rope bridge. Due to the rigorous strain the rope bridge
endures, it should be replaced at the earliest signs of wear.
Bridge should be carefully inspected prior to each use. This
inspection should include but not be limited to: rope cuts, nicks,
tears, kinks, abrasions, burns, excessive swelling, excessive
jacket wear, discoloration, broken, fraying, or unraveling fibers,
loose stitching, chemical or physical exposure. Failure to
regularly inspect and replace the rope bridge could result in
injury or death.
Only use Notch rope bridges where one end is still equiped with
a manufacturer-supplied Double Fisherman's knot and tie the
other end in the same way.
WARNINGS:
• Manufacturer's instructions shall be provided by the user of
this product. If additional copy is needed, contact Notch
Equipment.
• Completely read, understand, and follow all instructions,
warnings, and cautions pertaining to this particular harness
and all associated equipment before use. Failure to do so
could result in serious injury or death.
•Make sure the markings on the product are legible
• Service (repairs) may only be carried out by the manufacturer
or a center authorized by the manufacturer.
Tabla de contenido
loading

Productos relacionados para Notch Sentinel

Este manual también es adecuado para:

71-448-01

Tabla de contenido