Insulation Spacer - Panasonic TY-CE42PS20 Instrucciones De Instalación

Fitting procedure
5. Preparing the plasma display
Attaching the insulation spacers
Place the front surface of the plasma display on a clean
cloth that has no dirt or foreign objects on it, and follow the
procedure below.
If the plasma display has any protruding parts, take care not
to scratch or damage them.
Remove the four caps from the plasma display using a
Phillips head screwdriver.
Note
• Keep the caps that were removed in a safe place.
(They will be required if you use the pedestal.)
Using the supplied Allen wrench
Allen head countersunk screws
and 4 insulation spacers
caps were removed as shown in the figure on the right.
(Tightening torque: 3 to 4 N•m)
6. Mount the plasma display in the ceiling unit
Engage the upper insulation spacers of the plasma
display with the cutouts of the ceiling-hanging
bracket, and slowly lower the display into place.
While lifting the plasma display slightly, insert the
lower insulation spacers into the holes at the lower
part of the ceiling-hanging bracket.
CAUTION
• If the plasma display is lifted too much, its top part will
become disengaged from the ceiling-hanging bracket.
16
, mount the supplied 4
, 4 dished toothed washers
at the locations where the

Insulation spacer

Phillips head screwdriver
Cap
Blanket
Blanket
①
Cutout
②
⑬
⑦
⑧
⑨
①
②
Cutout