checklist:
ITEM DESCRIPTION
1
Is voltage correct?
2
Is pump permanently energised
regardless of evaporator operation?
3
Is overflow switch (purple wire)
correctly wired to cooling wire to
ensure unit will not operate in case
of pump failure or blockage?
4
Is piping & wiring in accordance with
manufacturers instructions?
5
If alarm is wired in, is overflow switch
(orange wire) correctly wired to ensure
alarm operation in case of pump
failure or blockage?
6
Is pump correctly sized to evaporator
condensate output?
Backflow prevention guidelines:
• Ensure that discharge tube ends above water level in evaporator tray.
FALSE CEILING
3
ITEM DESCRIPTION
7
Is maximum head within pump limits?
8
Is intake hose watertight?
9
Is discharge hose watertight?
10
Is breather tube installed?
11
Is pump/reservoir assembly level?
12
Is float in position?
13
Is magnet facing upwards on float?
14
Is filter fitted?
15
Has provision been made to eliminate
backflow?
16
Is drain outlet tube clear of
restrictions?
END OF DISCHARGE TUBE
WATER LEVEL IN TRAY
Installation: Wall-mounted Lineset Cover - A
ASP-ML-115 OR ASP-ML-230 PUMP FOR ASPEN SLIMLINE SERIES.
1
Select left or right hand side of evaporator for lineset, drain & electrical connections.
A
2
Disassemble elbow. Place elbow back flat on wall at least 2" away from evaporator to
allow space for flashing. Line up bottom of elbow with bottom of evaporator unit,
make sure elbow is plumb, and secure to wall using screws and plugs provided.
MINIMUM 2"
MUST BE
LEVEL
4
Cut length of lineset cover to suit gap between evaporator and centreline of coupler.
Disassemble lineset cover and fit bottom half between coupler and evaporator.
Secure to wall using screws and plugs provided.
B
3
Insert 1 coupler into opening of
elbow facing evaporator.
CUT TO LENGTH
4