Intended Uses; Allowed Environmental Conditions; Noise Level; Storage - Ghibli & Wirbel Power Indust AX60 Z22 Uso Y Mantenimiento

Equipe para uso en area clasificada, con atmósferas potencialmente explosivas
Tabla de contenido
1.5

Intended uses

These specific vacuum cleaner models have been designed, built and protected for vacuuming dusts and
solid materials only, using special filters.
Warning!
Always use specific filters for the type of dust or materials to be vacuumed.
Any other use is considered IMPROPER.
The vacuum cleaner is in any case intended for professional industrial use.
1.6

Allowed environmental conditions

To ensure the correct operation of the vacuum cleaner, this must be positioned protected against
atmospheric agents (rain, hail, snow, fog, dusts in suspension, etc.) with an environmental running
temperature between 5°C and 45°C and relative humidity not above 70%.
The work environment must be clean and well-enough lit.
1.7

Noise level

Noise tests have been performed in compliance with the Machines Directive 2006/42/CE. The phonometric
test results on this specific model correspond to the following acoustic pressure values (at 1 meter distance
from the vacuum. and at 1,60 mt. height, where there is the most noisy part of the vacuum):
Hand-arm vibrations given by the vacuum are lower than 2,5 m/s2
Attention!
Pursuant to articles L.D. 81/08, workers exposed to sound pressure levels above 85 dB (A) must be
protected by special individual protection devices.
It is therefore necessary, if such working conditions exist, to provide workers with such approved
individual protection devices and to inform them of the risks relating to noise exposure.
1.8

Storage

Remove the filter and clean it, empty the container and store the vacuum cleaner in a place protected
against atmospheric agents with a temperature between 0°C and 40°C. Cover with a nylon sheet to prevent
accumulation of dust.
1.9

Scrapping

In case of scrapping, all the component parts of the vacuum cleaner will have to be disposed of through
adequate disposal channels in accordance with applicable legislation.
Before scrapping, all plastic and rubber parts will have to be separated from the electrical material.
Parts made of plastic, aluminium and steel only may be recycled if collected by special centres.
74 dB (A)
ENGLISH - 7 -
Tabla de contenido
loading

Tabla de contenido