KENMORE ELITE 796.6142 Manual De Uso Y Cuidado página 33

P Oblem
Error code: tel or
tEE
Display shows error
code: PS (electric
dryers only)
Lint on clothes
Excess static in
clc¢_hes after drying
Steam Features Not
Working
BEFOEE CALLING FOR SERVICE (continued)
Possible Cause SolutiOns
Temperature sensor failure. Turn off the dryer and call fer service.
Power cord isconnected
incorrectly.
Lint filter not cleaned properly.
Laundry not sorted properly.
Excess static in clethes.
Dryer is overleaded.
Tissue, paper, etc., left in
_eckets.
Fabric softener is net used or
used incorrectly.
Clothes dried toe long (over
dried}.
Drying synthetics, permanent
press,or synthetic blends.
Garments are still wrinkled at
the end of the STEAM REFRESH
cycle.
Water drips down the door
during steam cycles.
Odors are not completely
removed at the end of the
STEAM REFRESH cycle.
White (N) and red (L2) wires on power cord. Check power
cord connections for neutral connection on the center
terminal. 240 volts applied to the control, so it will protect
itself.
Remove the lint from the filter before every toad. With the
lint removed, held the filter up tea light to see if it is dirty
or clogged. If it looks dirty, follow the cleaning instructions.
With some loads that produce high amounts of lint, it may
be necessary to clean the filter during the cycle.
Some fabrics are lint producers (i.e., a fuzzy white cotton
towel) and should be dried separately from clethes that are
lint trappers (i.e., a pair of black linen pants}.
Use a fabric softener to reduce static electricity. Be surete
follow the manufacturer's instructions. Over drying a load of
laundry can cause a buildup ef static electricity. Adjust settings
and use a shorter drying time_ or use AUTO DRY cycles.
Divide extra large loads into smaller loads fer drying.
Check pockets thoroughly before washing and drying clothes.
Use a fabric softener er the STATIC SHIELD option, if
equipped, to reduce static electricity. Be sure te follow the
manufacturer's instructions.
Over drying a load of laundry can cause a buildup of static
electricityoAdjust settings and use a shorter drying time_or
use AUTO DRY cycles. Select a LESS DRY setting on AUTO
DRY cycles, if necessary.
These fabrics are naturally more prone to static buildup. Try
using fabric softener, or use LESS DRY and/or shorter TIMED
DRY time settings.
Load only ene to five garments (or a single bulky item).
Do not mix fabric types. STEAM REFRESH is most effective
on 70/30 cottoniPolybtends. Do not use on ]00% cotton
items.
Steam is invisible. However, under some conditions_ the
condensed fog may be seen, or condensation wil! form
on the inside of the door glass and may be seen dripping
down the glass.
Some odors are dimcult to remove. Fabrics containing
certain dimcult odors or very strong odors may not refresh
weft and should be washed er dry cleaned instead.
33