Idiomas disponibles
Idiomas disponibles
NOTE: The indoor alarm/lamp control module can
be purchased separately (Model RM249). Contact
your local retailer.
Your indoor alarm/lamp control module is ready to
plug in and use. There is no installation required!
This module sounds four distinctive and easily heard
warning tones and can turn on any lamp up to 300
watts that is plugged into the module. Any Regent model
MS249 outdoor motion detector set to the same house code
as the indoor alarm/lamp module will activate the module to
sound an alarm and turn on the lamp plugged into it. Use up to
four detectors and indoor alarm/lamp modules in each house. NOTE:If you are not
receiving adequate performance using a given house code, move the module
to a different outlet. Remember, both the sensor and module must be on the
same house code at any given time.
Step 1: Plug lamp into the module (optional). Make sure the lamp does not exceed 300
watts and that the switch on the lamp is in the ON position. Make sure MODE
OF OPERATION switch is in any position except OFF.
Step 2: Plug module into any wall outlet. If the outlet is a switched outlet, make sure wall
switch which operates the outlet is in the ON position. The module is now on.
Allow the module to stabilize for 15 seconds. The module may sound a tone
sequence during stabilization. This is normal.
Step 3: Activate outdoor motion detector. If the outdoor sensor is set to the same house
code as the indoor alarm/lamp module, module will sound a distinctive warning
tone sequence. A volume control (HIGH, MEDIUM, LOW, OFF) is located on the
side of the module to set the desired sound level. If you desire the lamp to come
on but do not want the alarm to sound, turn the volume control to OFF.
If you want to turn off both the alarm and lamp, slide MODE OF OPERATION
switch to OFF.
Alarm tone sequence
The tone sequence corresponds to the house code setting so that you can tell which
outdoor light is being activated (if more than one is in use).
House Code #1 = Single tone repeats two times
House Code #2 = Double tones repeat two times
House Code #3 = Triple tones repeat two times
House Code #4 = Quadruple tones repeat two times
Lamp control
Lamp control
At night and in AUTO mode, the indoor lamp will also turn on when motion is detected. If
the outdoor sensor is in the AUTO mode, the lamp will only turn on at night (when in
AUTO mode, the indoor lamp will only turn on when the outside lights turn on). The
indoor lamp (when activated in the AUTO mode) will remain on for 10 minutes after
motion ceases outdoors and then will automatically turn off regardless of the "time on"
setting of the sensor.
Manual lamp control
The indoor lamp can be easily turned on and off manually, both day and night, by sliding
the MODE OFOPERATION switch on the left side of the module to LAMPON. While the
lamp is manually switched on, the alarm will continue to sound tone sequences when
motion is detected. To return to the lamp only coming on with motion, slide the switch
back to AUTO.
L
L
A
LManual lamp control
5
Volume
control
Modes of
operation
Lamp
plug-in
House
codes
P
