Using The Tools - Hoover SteamVac F5835900 El Manual Del Propietario

To clean floor
Read Before you begin cleaning
instructions on page 10.
Do not use the SteamVac deep cleaner
on hardwood floors.
Fill clean solution tank with HOOVER
Bare Floor Cleaner (available at additional
cost if not included with your model)
according to instructions on pages 7 and
8.
Do not use any type of wax with your
SteamVac™ deep cleaner.
Dry hands and plug deep cleaner into a
properly grounded outlet.
Step on handle release pedal and lower
handle to operating position; turn deep
cleaner ON.
To release solution, press trigger. Slowly
move deep cleaner forward and back-
ward over area to be cleaned.
To pick up dirty solution, release trigger
and slowly move deep cleaner over area
where solution has just been dispersed.
Use both forward and reverse strokes.
Empty recovery tank when the motor
sound becomes higher pitched and
there is a loss in suction (see "Automatic
shut-off", page 7).
When finished cleaning, follow "After
cleaning" instructions on page 9.
Remove attachment from nozzle and
rinse in clear water. Do not remove
plastic screen or foam from attach-
ment.
3-7
D
2. Step on handle release pedal (D) and
lower deep cleaner handle until it rests
on the floor.
Unlatch back part of recovery tank and
remove lid.

Using the tools

3-5
A
A. Powered hand tool has rotating
brushes for extra scrubbing action on
small carpet areas, carpeted stairs and
upholstery.
B. Stair/upholstery nozzle has a built-in
brush to help provide the scrubbing
action some spots may need for
removal.
3-8
3. Remove recovery tank front panel (E)
by sliding it straight up.
How to attach hose
Disconnect deep cleaner from electri-
cal outlet.
3-6
C
B
1. To prevent possible leaking, remove
clean solution tank by pressing down on
tank handle (C) and pulling forward; set
tank aside (do not set tank on furniture).
Remove hose from storage rack.
3-9
E
4. Replace panel with converter (F).
Slide converter halfway down opening
until it is firmly in place.
F
Continued
11