Heath Zenith 7162 Manual De Instrucciones página 4

IMPORTANT: The "C" batteries are used when the rechargeable
solar battery is depleted. When the "C" batteries are depleted, a
red LED will flash inside the motion sensor and the "C" batter-
ies will need to be replaced.
NOTE: To extend the life of the batteries, this light only works
in the dark (night time).
3. Insert the alignment tabs on the top of the battery cover with
the slots on the rear of the light fixture (see Figure 4).
4. Rotate the battery cover toward the light fixture until it snaps
into place (see Figure 4).
IMPORTANT: The rechargeable solar battery is activated when
the battery cover is installed.
5. Slide the rear of the light fixture down onto the mounting plate
until it snaps into place (see Figure 5).
Mounting the Solar Panel
1. Place the solar panel against the mounting surface and mark the
mounting holes (see Figure 6).
• If mounting to a wooden surface, drill two 3/32 in. holes into
the mounting surface. Install the two mounting screws through
the base and into the mounting surface.
• If mounting to wall board or brick, drill two 7/32 in. holes
into the mounting surface. Insert the wall anchors and attach
the base using the two mounting screws.
IMPORTANT: Caulk around the base and on top of the screw
heads after installation.
2. Rotate the solar panel to the desired angle (see Figure 7).
IMPORTANT: The solar panel must receive as much direct sunlight
over the course of the day as possible. Keep in mind that shadows
may block the sunlight from reaching the solar panel during the
day.
3. Carefully route the solar panel cable to the light fixture. Remove
the rubber plug from the bottom of the light fixture and insert
the end of the cable into the opening (see Figure 8). Note: Wrap
any excess solar panel cable around the cord management system
located on the rear of the solar panel. Leave enough loose cable
to form a drip loop.
IMPORTANT: Turn the control dial on the side of the sensor to
the OFF position and allow the battery to charge with 3 to 7
days of full sunshine before testing (see Figure 9).
4
To see operational and troubleshooting information and videos,
go to www.hzsupport.com
Figure 4
W
UP
Figure 5
Figure 6
Figure 7
208824-02