Introduction; Tools Required; Product Ratings; Overview - Akron STYLE 9323 Instrucciones De Instalación, Funcionamiento Y Mantenimiento

1 Introduction

The following is intended to provide the basic instructions for installation, operation and maintenance of the Akron Brass
Style 9323 Navigator Pro Valve Controller . IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY, NOTE THE
SAFE OPERATIONAL REQUIREMENTS, WARNINGS, AND CAUTIONS . USE THIS PRODUCT CORRECTLY, AND WITH
CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED . FAILURE TO DO SO MAY CAUSE DAMAGE, OR PERSONAL
INJURY, AND WILL INVALIDATE THE WARRANTY!

2 TOOLS REQUIRED

• Utility Knife
• Electricians Pliers (multipurpose, stripping and crimping)
• Appropriate electrical connectors and harnesses
• 5/32 Allen key
• 3/8 wrench

3 PRODUCT RATINGS

Model: 9323
Operating Voltage: 10 – 32VDC; 10V minimum required AT THE VALVE for proper operation .
Operating Current: 2-10A @ 12VDC, 1-5A @ 24VDC (depends on valve type)
Weight = .3 lbs [ .14 kg]
Operating Temperature: -40°C - 70°C
Storage Temperature: -40°C - 85°C
Ingress protection: IP67 equivalent
J1939 CAN networked

4 OVERVIEW

The Style 9323 Navigator Pro controller allows the user to control an Akron Brass electric valve . It is designed to be used
with an Akron Brass Swing-Out valve only . The Style 9323 is a display interface only and does not contain the electron-
ics required to drive the valve open and closed . The electronics that drive the valve are located on the electric actuator
mounted to the valve . The motor driver electronics are installed on all electric valves supplied with a 9323 Navigator Pro .
The Navigator Pro system communicates via J1939 CAN protocol and is a distributed system . The display is strictly a
user interface that allows the user to view information and send commands to the valve . The motor driver on the electric
actuator is the unit that interprets commands from the display and drives the valve .
Page 02