Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Rear Panel
6
8
1. DC In: Use the included power adapter (12V, 2A, center-positive) to connect this jack to a
power outlet.
2. Power Button: Press this button to power Timbre Wolf on or off.
Important: After powering Timbre Wolf on, let it warm up before using it. Its tuning can be
affected by the temperature.
3. Cable Restraint: You can secure a cable to this restraint to prevent it from accidentally
unplugging.
®
4. Kensington
Lock Slot: You may use this Kensington lock slot to secure the Timbre Wolf
to a table or other surface.
5. USB Port: Use a standard USB cable to connect this port to an available USB port on
your computer. This connection lets Timbre Wolf send and receive MIDI over USB to and
from your computer.
6. Main Out: Use a standard 1/4" (6.35 mm) TRS or TS cable to connect this output to the
input of an audio interface, mixer, amplifier system, etc.
7. Voice Outs 1–4: Use standard 1/4" (6.35 mm) TRS or TS cables to connect these outputs
to the inputs of an audio interface, mixer, amplifier system, etc. Each Timbre Wolf voice is
sent separately to each of these outputs, so you can record or mix them independently of
each other. When a cable is connected to one of these outputs, that voice will be removed
from the Main Out and Phones Out. The Howl knob does not affect these outputs.
8. Phones Out: Connect your standard 1/4" (6.35 mm) stereo headphones to this output.
9. MIDI In: Use a standard five-pin MIDI cable to connect this MIDI In to the MIDI Out of an
external MIDI device (e.g., another MIDI controller).
10. MIDI Out: Use a standard five-pin MIDI cable to connect this MIDI Out to the MIDI In of an
external MIDI device (e.g., a synthesizer, sequencer, drum machine, etc.).
11. MIDI Thru: Use a standard five-pin MIDI cable to connect this MIDI Thru to the MIDI In of
an external MIDI device (e.g., a synthesizer, sequencer, drum machine, etc.). All messages
sent from this MIDI Thru are identical to the messages received by Timbre Wolf's MIDI In.
12. Gate Trig Out: Use a standard 1/8" (3.5 mm) TS cable to connect this output to the input
of an optional external device that can receive Timbre Wolf's Gate (trigger) messages.
13. Gate Trig In: Use a standard 1/8" (3.5 mm) TS cable to connect this input to the output of
an optional external device to send Gate (trigger) messages to Timbre Wolf.
6
7 7 7 7
9
11
10
12 13
3
1 2
4
5
Tabla de contenido
