Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Tools and Parts
Gather the required tools and parts before starting installation.
Tools Needed
9/16" socket wrench
■
Parts Supplied
4 ft (121.9 cm), 6 ft (182.9 cm), and 8 ft (243.9 cm) Workbench
Workbench outer legs
■
(2 welded sets)
Workbench inner legs (4)
■
Workbench back panel
■
Workbench top
■
1/2" (12.7 mm) Leveling legs
■
(4)
M8 hex-head bolts (5)
■
3/8" (9.5 mm) x 1½" (3.81 cm)
■
screws (15)
NOTE: Assemble and adjust this workbench upside down according to the following illustrations. Be sure that the workbench top is flat
on the floor and the legs are in the air. To protect the workbench top during assembly, it is recommended that you place the wood top
upside down on the cardboard provided in the package.
1. Prepare workbench top
Lay the workbench top (P4) upside down on a clean surface to
expose the holes for the leg assembly sets.
ASSEMBLY INSTRUCTIONS
Adjustable wrench
■
Wingnuts (8)
■
5/16" (8 mm) hex-head
■
bolts (8)
ID 8 mm x OD 12.5 mm
■
x THK 3 mm washer (8)
Bushing (8)
■
5 mm wrench (1)
■
Install Legs and Back Panel
Workbench Use Requirements
WARNING
Excessive Weight Hazard
Use two or more people to move and assemble
workbench.
Failure to do so can result in back or other injury.
Intended for use in a garage.
■
Maximum weight limit is 3,000 lbs (1,360 kg).
■
Adding casters to this workbench could be a tipping hazard.
■
Unpack the Workbench
1. Unpack the legs and hardware from the box. Verify contents.
See the "Parts Supplied" section.
NOTE: Workbench Legs come fully assembled.
2. Remove the back panel and set it aside.
NOTE: Leave the workbench top on the cardboard during
assembly.
3. Remove the corners from the workbench top. The bolt holes
should be visible. Inspect workbench top prior to assembly.
4. Dispose of/recycle all packaging materials.
2. Place leg assemblies
Place each outer leg assembly (P1) on the workbench
underside. Line up the holes in the outer leg assembly sets
with the holes on the bottom of the workbench top (P4). Each
outer leg assembly end has two holes that must face the three
holes on the back of the wood top for installation of the back
panel.
5
Tabla de contenido
