Installation And Safety Instructions - Kathrein EXR 2508 Manual Del Usuario

Installation and safety instructions

•
The equipment described is designed solely for the installation of satellite receiver systems.
•
Any other use, or failure to comply with these instructions, will result in voiding of warranty cover.
•
The equipment may only be installed in dry indoor areas. Do not mount on or against highly combustible
materials.
•
The equipment must be provided with an earthing wire (Cu, at least 4 mm
•
The safety regulations set out in the current EN 60728-11 and EN 60065 standards must be complied with.
• Fixings: Wood screws, max Ø: 4.5 mm
•
Connectors: RF plug 75 Ω (series F) to EN 61169-24.
•
Unused subscriber ports should be closed off with 75 Ω resistors (e.g. EMK 03).
Current-carrying device EXR 2508
•
Do not open or tamper with the unit!
• When working on the system always unplug the mains plug from the wall socket!
•
Ensure adequate clearance! Clearance all round at least 5 cm!
•
The unit must not be mounted on the ceiling.
•
Free circulation of air must be possible to discharge the heat emitted by the unit. Risk of overheating!
•
Permissible ambient temperature –20 to +55°C
Important:
•
No liquid-fi lled items may be placed on top of the power supply unit.
•
The power supply unit must not be exposed to dripping or splashing water.
•
The mains plug must be easily accessible and operable.
•
The only reliable method of disconnecting the unit from the mains is to unplug it.
Therefore the mains plug must be easily accessible.
• If the inner cable conductor diameter is
greater than 1.2 mm or in case of burr, the device
sockets may be destroyed.
Electronic equipment is not household waste in accordance with directive 2002/96/EC OF THE EUROPEAN
PARLIAMENT AND THE COUNCIL dated 27
it must be disposed of properly.
At the end of its service life, take this unit for disposal to an appropriate offi cial collection point.
Internet: http://www.kathrein.de
KATHREIN-Werke KG . Anton-Kathrein-Straße 1 - 3 . P.O. Box 100 444 . 83004 Rosenheim . GERMANY . phone +49 8031 184-0 . Fax +49 8031 184-306
Max. 2 mm excess
length
Clamping torque max.
3 Nm
(danger of overwinding)
January 2003 on used electrical and electronic equipment,
th
).
2
Diameter
0.6-1.2 mm
free of burrs