Setup Instructions - Kathrein DVB-S-UKW Manual De Instrucciones

Setup instructions

The setting of the DVB-S-FM UFO 313 8-way transcoder is performed via the central controller of the base unit UFG 3xx or UFG 4xx.
General instructions for setting, such as the functions of the buttons, can be found in the application instructions for the UFG 300 manual
controller.
1. Setting the input
1.1 Selecting the signal input
Inp. 1 A
27.500 MS/s
Inp. 2 A
27.500 MS/s
Display of the inputs used for the two receivers. A/B changeover, input Sat-IF frequency, symbol rate, code rate. The selection A or B
refers to the input socket for the respective input. Select the parameters using the cursor keys to and use the up/down scroll keys to
select the input socket A or B.
***
DiSEqC -A
DiSEqC -B
After the " " button has been pressed a submenu appears on the A/B changeover f eld, showing the channel unit type and the
receiver unit that is addressed. Here the up/down keys can be used to select the DiSEqC
via the RF socket of the input A or B.
Pressing the " " button takes you back to the previous display in the main menu.
1.2 Selecting input frequency
Inp. 1 A
27.500 MS/s
Inp. 2 A
27.500 MS/s
Select the "Input frequency" parameter and use the up/down keys to change it. The frequency can also be changed by numeric input.
*** UFO
SNR 12 dB
BER 1.0E-07
After the " " button has been pressed a submenu appears on the A/B changeover f eld, showing the channel unit type and the receiver
unit that is addressed. The SNR of the signal being received, together with the bit error rate BER that is determined, are displayed.
Pressing the " " button takes you back to the previous display in the main menu.
1666 MHz
3/4
1354 MHz
3/4
***
Off
Off
1666 MHz
3/4
1354 MHz
3/4
313 -E1 ***
2 / 6
signal which should be transmitted
TM