Leveling Bolts To Pilaster - Bradley 400 Serie Manual Del Usuario

Installation
2b Continuous Aluminum Brackets to Wall (Optional)
On end panel and pilaster applications, position the bracket
with the ear facing toward the inside of the stall.
Pilaster bracket is shown here; 1-1/4" opening brackets are for
pilasters, and 1" opening brackets are for panels.
Brackets are used as templates, but since the hole patterns
may be different, the brackets may not be interchangeable.
Place the bottom of each continuous
A
bracket at the established level line .
Center the bracket opening on the
pilaster/panel plumb line .
Using the bracket as a template, mark the
B
hole locations on the wall . Remove the
bracket and drill a Ø5/16" hole (min . 2"
[51mm] deep) at each hole location .
Insert the plastic anchors in all holes and
C
secure the brackets to the wall with the
#14 x 2" stainless screws provided .
3

Leveling Bolts to Pilaster

3" Pilaster
A
Use leveling bolt(s) to adjust height of pilaster
as indicated based on pilaster width .
Bradley • HDWT-INSTR-009 Rev K; ECN 17-14-007
Powder Coated & Stainless Steel Restroom Partitions, Floor-Mounted with Overhead Brace — Series 400
One-Eared
4" - 14" Pilaster
Bracket
18" - 24" Pilaster
4" - 8" pilasters have a single, 1-piece bracket that uses a
leveling bolt in the center to adjust the pilaster height.
C L
Two-Eared
Bracket
3/21/2018 7