MTD 19A30003OEM Manual Del Operador página 12

3. Install the grass catcher cover onto the bag support
assembly, as shown in Figure 4-13. The grass catcher cover
goes inside of the two mounting tabs on the bag support
assembly.
4. Slide the hinge pin into the hole located on the mounting
tab, as in Figure 4-14. Use the cut-out window (See inset in
Figure 4-14) to line up the hinge pin on the other side and
push pin all the way in until it reaches the end-stop. At this
point the pin clips into place and is secured by a tab in the
bagger cover. See Figure 4-15.
12 S 4 — A
ection SSembly
Figure 4-13
Figure 4-14
& i
nStAllAtion
Figure 4-15
5. If not already flipped forward, flip seat forward to allow for
bag and upper tube assembly steps.
6. Open bagger cover by pushing in on the rear, right-side
tab with your right hand, as shown in (1) of Figure 4-16, and
lifting the cover with your left hand in the center rear of the
bagger cover, (2).
2
Figure 4-16
1