Tabla de contenido
Idiomas disponibles
Idiomas disponibles
1. General Information
Before installation, read the following instructions carefully.
performance. Closely following these instructions will eliminate potential operating problems, assuring years of trouble-free service.
•
Risk of electric shock. Always disconnect the pump from the power source before handling or making adjustments.
•
These pumps are not to be installed in locations classified as hazardous in accordance with the National Electric Code,
ANSI/NFPA 70.
•
The electrical connections and wiring for a pump installation should only be made by qualified personnel.
•
This pump is supplied with a grounding conductor or a grounding-type attachment plug. To reduce the risk of electric shock, be
certain that the grounding conductor is connected only to a properly grounded control panel or, if equipped with a grounding-type
plug, that it is connected to a properly grounded, grounding-type receptacle.
•
Do not bypass grounding wires or remove ground prong from attachment plugs.
•
Do not remove cord and strain relief, and do not connect conduit to pump.
•
Do not use an extension cord.
•
The installation must be in accordance with the National Electric Code and all applicable local codes and ordinances.
•
Do not use these pumps in water over 120° F.
•
Do not lift macerating tank by the power cord. Use the hand grip overhang on the cover.
1-1
INSPECTION UPON RECEIPT.
The Ascent is shipped in 3 separate packages, the toilet tank (model ASC-2), toilet bowl (model ASC-3) and macerating unit
(model ASC-1). The shipping containers should be immediately inspected for damage that may have occurred in shipment.
Exercise care in opening the shipping container to avoid damage to the contents. Remove any blocking and cushioning from
within the containers.
Check all cushioning for spare parts before discarding. Visually check the pump and any spare parts for damage. Check for
damaged electrical wires, especially where they exit the macerating tank. Report any damage or shortage of parts. This will
insure that the impeller and cutter is free of any seizure due to prolonged storage.
1-2
STORAGE BEFORE USE
Liberty pumps are shipped from the factory ready for installation and use. If storage is necessary, the pump should remain in
its shipping container. It should be stored in a warehouse or storage shed that has a clean, dry temperature-stable area where
the pump and its container should be covered to protect it from water, dirt, dust, etc. The ends of the cables - (plugs) must be
protected against moisture.
1-3
IMPORTANT. Do not allow the pump to freeze. If the home is allowed to freeze during winter months, ensure the macerating
unit and toilet is evacuated of water before closing the home. The tanks should be filled with plumber's anti-freeze to protect
against freezing conditions.
2. Introduction
2-1
The macerating system can simultaneously receive wastewater from several sanitary fixtures, e.g. bidet, sink, shower,
bathtub, or urinal, but only one water closet per unit.
2-2
Macerating systems are designed for the disposal of human waste, toilet paper and water. They are not intended to replace
kitchen waste, neither are they intended to be used for the disposal of waste water from such pumped appliances as
dishwashers and clothes washers.
2-3
Sanitary fixtures connected to the macerating system must be located on the same level.
©Copyright 2008 Liberty Pumps Inc. All rights reserved.
Each Liberty pump is individually factory tested to insure proper
2
Tabla de contenido
