Ryobi RPW120HS Manual De Utilización página 20

EN
FR DE ES IT PT
Before using this product, familiarize yourself with all
operating features and safety rules.
DETERGENT TANK
Remove the cap from the detergent tank to add detergent
to the pressure washer.
HIGH PRESSURE TRIGGER
Depressing this trigger allows you to dispense water at
high pressure.
HIGH PRESSURE TRIGGER LOCK-OUT
The trigger lock-out prevents accidental use of the high-
pressure trigger.
HYDROSURGE(TM) /LOW PRESSURE (HIGH FLOW)
LEVER
Use this lever when you want to rinse with water alone,
or apply a combination of water and detergent at low
pressure.
ON/OFF SWITCH
This switch turns the pressure washer on and off.
TELESCOPIC HANDLE
Lower the telescopic handle for convenient storage.
GUN/LANCE
The gun/lance features two outlets — one for high
pressure spray and one for low pressure (high flow)
spray.
ASSEMBLY
UNPACKING
This product requires assembly.
■ Carefully cut the box down the sides then remove the
product and any accessories from the box.
WARNING:
This new product has been shipped in a
partially assembled condition as described
below.
If in doubt, call Ryobi Customer Service for assistance.
Operation of a product that may have been improperly
preassembled could result in serious personal injury.
■ Inspect the product carefully to make sure no
breakage or damage occurred during shipping.
■ Do not discard the packing material until you have
carefully inspected and satisfactorily operated the
product.
■ If any parts are damaged or missing, please call
Ryobi Customer Service for assistance.
RPW120HS-25lgs.indd 17 RPW120HS-25lgs.indd 17
NL SV DA NO FI HU CS RU
English(original instructions)
INSTALLING THE WHEELS
See Figure 3.
■
■
■
■
NOTE: The hitch pin should be pushed into the axle
until the centre of the pin rests on top of the axle.
■
ATTACHING THE HANDLE ASSEMBLY
See Figure 4.
■
■
■
ASSEMBLING THE GUN/LANCE
See Figure 5.
■
■
ATTACHING THE HIGH PRESSURE AND LOW
PRESSURE HOSES TO THE GUN
See Figure 6.
■
17
RO PL SL HR ET
WARNING:
If any parts are damaged or missing do not
operate this product until the parts are replaced.
Use of this product with damaged or missing
parts could result in serious personal injury.
WARNING:
Do not attempt to modify this product or create
accessories not recommended for use with this
product. Any such alteration or modification
is misuse and could result in a hazardous
condition leading to possible serious personal
injury.
WARNING:
Do not connect to power supply until assembly
is complete. Failure to comply could result
in accidental starting and possible serious
personal injury.
Locate the axles, hitch pins, and wheels.
Slide the axle through the hole in the centre of the
wheel.
Lift the machine and slide the axle into the wheel
mounting hole in the machine base as shown.
Push the hitch pin into the hole on the end of the axle
to secure the wheel assembly.
Repeat with the second wheel.
Line up the handle assembly with the holes.
Depress the button on the handle assembly and
insert into the holes on the pressure washer. Press
down on the handle assembly until the button on the
handle clicks into place.
Lower both collars on the handle and rotate
clockwise until secure.
Push the two ends of the gun/lance together so that
the holes inside each end are aligned.
Lower the locking collar and rotate counter clockwise
to tighten securely.
The low pressure hose is the clear tube with the
LT LV SK BG
09-10-28 09-10-28 10:59 10:59