Single-Phase Three-Line Circuit; Input Voltage And Current; Backlight; Auto Power Off - koban KPF 01 Manual De Instrucciones

KPF-01
Power harmonic clamp meter

Single-phase three-line circuit

The process for measuring power and power factor for single-phase three-
line circuit is the same as that for single-phase two-line circuit, where the
black clip is connected to the middle wire, and the red clip and clamp-type
sensor are simultaneously connected to all test wires.
Red
Black

Input Voltage and Current

During power measurement, if input voltage is over 600 V (RMS) or current
over 200 A (RMS), "OL" symbol will be displayed and bar symbol shown in
full scale.

Backlight

Press button longer than 1s, the backlight will be lit up, and it will then
be automatically turned off after about 20 seconds.

Auto Power Off

1. If there is no function change or button press fo 10 minutes ,the meter
will automatically turn power off , When the meter is automatically
powered off, be sure to switch the knob to "OFF" position; turn on the
meter after 5 seconds.
2. Holding the button
automatic power -off
Instructions manual | 28
m
down while turning the meter on,Disables
Black
Red
m
www.grupotemper.com