Rola 59310 Guía De Instrucciones página 9

ASSEMBLY INSTRUCTIONS
59307 1-1/4 in. / 59308 2 in. Base Units
LOADING BIKES (continued)
Securing by the frame:
1. Be sure rotating arm assembly (G) is on the rear cradle tube side (E).
See page 6 figure 4a for reference. Place rotating arm assembly (G) in
the "unlocked" position. Depress grip trigger and move grip up shaft to
maximum height. FIG 1.
Note: It may be easier to remove grip completely, depending on bike
style.
2. Lift bike onto carrier and place front wheel onto front wheel tube
cradle (D). While supporting bike with one hand, rotate arm assembly
(G) upward to vertical position FIG 2. Note: Arm assembly (G) must be
locked in the vertical position to properly secure frame. Reinstall grip
(H) (if removed). Center "V" shape in hook frame and pull downward
on grip to secure FIG 3.*
3. If you are unsure that you pulled down hard enough on grip, push
down on the grip lever. This will move the grip downward one more
detent and lock the grip. FIG 4.
4. Secure rear tire by aligning rear cradle strap (F) with rear axle of bike.
Place strap through spokes while rotating tire as needed, then slide
into buckle. Pull downward on strap. FIG 5.
* NOTE: For frame mounting, hook must be as close to top tube/seat tube
intersection as possible FIG 3.
NOTE: If your strap is too short, or if you have a fat tire bike, replace
with longer strap (P) (supplied). Refer to page 12 for strap replacement
instructions.
5
1
2
Rear cradle tube
with strap
3
4
F
Rear cradle
strap
PAGE 9 59307_59308_59310_IN_Rev A • Questions? (800) 234-6992 • RolaProducts.com
H
Grip
Maximum height
Rotating arm
assembly
E
H
Grip
Grip lever
Grip triger
Grip lever
G
D
Front wheel tube
with cradle
Grip triger